TASER® Automatic shut-down Performance Power Magazine

1
X2™ Electronic Control Device Automatic shut-down Performance Power Magazine Models
Model
Part No.
Color
Automatic shut-down Performance Power Magazine
22011
Black
(APPM)
2
Specifications
Features
1. Housing material: High impact polymer
1. Designed for use with the X2 electronic control device (ECD).
2. Battery: Three lithium 3V cells
2. The APPM emits an audible alert for the last 2 seconds of the ECD
7
3. Operating and storage temperature range: –4 °F to
output cycle.
3. Installing the APPM into an ECD will change the ECD’s programming
122 °F [–20 °C to 50 °C]
to automatically stop the ECD’s output cycle at 5 seconds, even if the
4. At room temperature 77 °F [25 °C], the APPM provides
energy for approximately 500 5-second
trigger is continuously depressed. (The APPM also will affect ARC
3, 4,5,6
switch function if the system has been configured to do so.)
discharges.
Replacing the APPM with a PPM, or TPPM will reset the ECD and
disable the shut-off and audio alert features.
4. Dust and moisture resistant when properly installed in the X2 ECD.
,8
Physical Characteristics2
Characteristics
Dimensions (installed in TASER X2 ECD)
Length (L)
Height (H)
Width (W)
Weight
Height
2.13″ [5.4 cm]
2.75″ [7.0 cm]
1.25″ [3.2 cm]
2.6 oz [74 g]
4.25″ [10.8 cm]
1
2
3
4
5
6
7
8
Additional models available. Please contact a TASER International sales and customer service representative for more information.
Product specifications may change without notice; actual product may vary from picture.
The battery may lose 1 percent of its capacity per year.
Replace the APPM when the battery percentage readout drops below 20 percent; continued use at 0% could cause damage to the X2 ECD.
Material Safety Data Sheets (MSDS) related to lithium cells are available upon request.
Approximate firings figure is derived from controlled settings at room temperature; actual firings may be different due to environmental and usage
variance.
The cycle can be stopped by placing the safety switch in the down (SAFE) position.
Dimensions and weights are for reference only.
TASER International reserves the right to change this specification without notice.
X2™ and ‘Protect Life’ are trademarks of TASER International, Inc., and TASER® and © are registered trademarks of TASER International, Inc.
registered in the U.S. © 2012 TASER International, Inc. All rights reserved.
Page 1 of 1