INSTRUCTION FOR EMERGENCY LIGHTING FIXTURE CJB J-Box Mounted Emergency Light IMPORTANT! IMPORTANT SAFEGUARDS The battery in this unit may not be fully charged. After WARNING: RISK OF ELECTRIC SHOCK- NEVER CONNECT TO, DISCONNECT FROM, electricity connected to unit, let battery charge up for at OR SERVICEisWHILE EQUIPMENT IS ENERGIZED. least 24 hours. Then the normal operation of this unit should INSTRUCTION FOR EMERGENCY LIGHTING FIXTURE WARNING: FAILURE TO FOLLOW THESEpress INSTRUCTIONS AND WARNINGS MAY take effect. To check, the "TEST” button and the lights RESULT IN DEATH, SERIOUS INJURY OR SIGNIFICANT PROPERTY DAMAGE. on the unit should turn ON. For your protection, read and follow these warnings and instructions carefully before PAC6060W-E installing or maintaining this equipment. These instructions do not attempt to cover all installation and maintenance situations. I PAC6060W-P IMPORTANT SAFEGUARDS READ AND FOLLOW ALL SAFETY INSTRUCTIONS When using electrical equipment, basic safety precautions should always be followed including the following: IMPORTANT! The battery in this unit may not be fully Rated for temperature range of 10℃ to 40℃ (50℉ to 104℉). Used indoors only. electricity is connected to unit, let battery c Equipment should be mounted in locations and at heights where it will not be subject to least 24 hours. Then the normal operation of tampering by unauthorized personnel. Rated for temperature range of 10� -40� (50� -104� ). 4. Do not mount near gas or electric heaters. take effect. To check, press the "TEST” butto Used indoors only. 5. The use of accessory equipment is not recommended by the manufacturer and may cause on the unit should turn ON. unsafe condition. Equipment should be mountedPAC6060W-P in locations an and at heights where it will not be subject to tampering by unauthorized PAC6060W-E 6. Do not use this equipment for anything other than its intended use. personnel. 7. Servicing of this equipment should be performed by qualified personnel. 8. Disconnect AC power before servicing. Do not mount near gas or electric heaters. 1. 2. 3. I READ AND FOLLOW ALL SAFETY INSTRUCTIONS 1. 2. INSTRUCTION FOR EMERGENCY 3. LIGHTING FIXTURE 4. 5. 6. 7. 8. IMPORTANT SAFEGUARDS The use of accessory equipment is not recommended by the manufacturer and may cause an unsafe condition. IMPORTANT! NOTE: Do not use this equipment for anything other than its basic intended use.not be fully should When using electrical Theequipment, battery in this unitsafety may precautions charged.always After be followed including the follo Servicing of this equipment should be electricity performed by qualified personnel. is connected to unit, let battery charge up for at least 24 hours. Then the normal operation of this unit should Disconnect AC power before servicing. READ AND FOLLOW ALL INSTRUCT take effect. To check, press the "TEST” button SAFETY and the lights on the unit should turn ON. 1. Rated for temperature range of 10� -40� (50� -104� ) . PAC6060W-P PAC6060W-E SAVE THESE 2. Used INSTRUCTIONS! indoors only. INSTALLATION 3. Equipment should be mounted in locations and at heights where it will not be subject to tampering b INSTALLATIONpersonnel. (J-BOX MOUNTING) When using electrical equipment, basic safety precautions should always be followed including the following: 1. Before installation, use tool to remove the 1) 4. Do near gas or electric(Fig heaters. Before installation, useaanot toolmount to remove thefaceplate. faceplate. (Fig 1) 1.1.Connect the battery wire.(Fig 1,Fig 2) IMPORTANT SAFEGUARDS 5. The use of accessory equipment is not recommended by the manufacturer and may cause an unsafe co (Fig Fig 3) (Fig Fig 3) (universal voltage 2. Connect wire of 120/277 to2,2,AC power from 120V-277V),then put the whole unit into J-box, READ ANDinput FOLLOW ALL SAFETY INSTRUCTIONS 6. Do not use this equipment for anything other than its intended use. 1. Rated for temperature rangescrews of 10� on -40� (50� -104� ) . on the face cover. (Fig 3) fix it by using corner, then put 7. Servicing of this equipment should be performed by qualified personnel. 2. Used indoors only. 4) 3. Turn on the AC powerDisconnect and press the "TEST" button servicing. to check(Fig the light. (Fig 4) power before 3. Equipment should be mounted in8.locations and at AC heights where it will not be subject to tampering by unauthorized 4.4. personnel. 4. Do not mount near gas or electric heaters. 5. The use of accessory equipment is not recommended by the manufacturer and may cause an unsafe condition. 6. Do not use this equipment for anything other than its intended use. 7. Servicing of this equipment should be performed by qualified personnel. 8. Disconnect AC power before servicing. SAVE THESE INSTRUCTIONS! INSTALLATION (J-BOX MOUNTING) 1. Connect the battery wire.(Fig 1,Fig 2) 2. Connect input wire of 120/277 to AC power(universal voltage from 120V-277V),then put the whole SAVE THESE INSTRUCTIONS! fix it by using screws on corner, then put on the face cover. (Fig 3) INSTALLATION (J-BOX 3. MOUNTING) Turn on the AC power and press the "TEST" button to check the light. 1. Connect the battery wire.(Fig 1,Fig 2) 2. Connect input wire of 120/277 to AC power(universal voltage from 120V-277V),then put the whole unit into J-box, Fig 1 fix it by using screws on corner, then put on the face cover. (Fig 3) 3. Turn on the AC power and press the "TEST" button to check the light. Fig 2 OPERATION Fig 4 CJB CJB CJB with Sensor RECYCLING INFORMATION All steel, aluminum and thermoplastic parts are recyclable. All cartons contain recycled materials. Please recycle responsibly. Hubbell Lighting, Inc. Life Safety Products • www.compasslightingproducts.com Copyright© Hubbell Lighting, Inc., All Rights Reserved • Specifications subject to change without notice. Printed in U.S.A. 603681_COM_CJB_INST_15-A