Shield Arc ® HYP High strength cellulosic electrode Classification AWS A5.5-96 EN 499-94 : E7010-G : E 42 2 Mo C 25 S M AW General description Cellulosic coated electrode for vertical down pipe welding Suitable for pipe with strengths X52 trough X65 Popular with welders Easy operability Low susceptibility to wagon tracks, windows and pinholes Welding positions Current type DC electr. + ISO/ASME PG/5Gdown Approvals LR 3,3Y TÜV + Chemical composition (w%), typical, all weld metal C 0.12 Mn 0.35 Si 0.12 Mo 0.35 V 0.02 Mechanical properties, all weld metal Condition Required: AWS A5.5-96 EN 499-94 Typical values AW 0.2% Proof strength (N/mm2) min. 390 min. 420 430 Tensile strength (N/mm2) min. 480 500-640 520 Elongation (%) min. 22 min. 20 26 Impact ISO-V(J) -20°C -30°C not required min. 47 75 50 Packaging, available sizes and identification Unit: Metal can Identification 138 Diameter (mm) Length (mm) Pieces / unit (nominal) Net weight/unit (kg) Imprint: 7010-G SAHYP 2.5 350 440 6.9 3.2 350 325 8.4 4.0 350 195 7.8 Tip colour: none 5.0 350 130 8.1 Shield Arc® HYP: rev. EN 15 Liability: All information in this data sheet is based on the best available knowledge, is subject to change without notice and can only be considered as suitable for general guidance Fumes: Consult information on Welding Safety Sheet, available upon request www.lincolnelectriceurope.com Shield Arc ® HYP Materials to be welded Code EN 10208-2 EN 10216-1 / 10217-1 API 5LX Gaz de France Type L 360, L 415 P 355 X52, X 56, X60, X65 X52, X63 S M AW Steel Pipe material Calculation Data Sizes Diam. x length Current range Current type (mm) 2.5x350 3.2x350 4.0x350 5.0x350 (A) 40-70 75-130 90-185 140-225 DC+ DC+ DC+ DC+ Arc time Energy Dep.rate - per electrode at max. current (s)* E(kJ) H(kg/h) Weight/ 1000 pcs. (kg) 15.7 26.0 40.0 62.3 Electrodes/ kg Electrodes/ kg weldmetal kg weldmetal B 1/N * stub end = 35 mm Welding parameters, optimum fill passes Welding position: Diameter (mm) 2.5 3.2 4.0 5.0 PG/5G down Current (A) 65 110 150 165 Application Advice Preheating pipe material L360 and L415 (X56 t/m X65) required (acc. EN 1011-1). Pipeclamps to be removed after finishing root pass, start welding”hot pass” immediately (within 5 min.) after root pass. Use electrode directly from metal cans. Use Fleetweld® 5P for lower hardness in the root pass 139