Building a Channel In ADVANCED CHANNEL DESIGN 2012 By Christian Shaw HYPACK® has a new ADVANCED CHANNEL DESIGN program released with HYPACK® 2012. The layout is completely new and it has some great features. This program, like the previous CHANNEL DESIGN programs, will create a channel design from your right, left and center line information. You can calculate volumes against these channels, or generate survey lines to be used in data acquisition or plotting in HYPLOT. Although the layout has changed a bit, the premise is still pretty much the same. The only thing that has changed is the order in which you enter data to create your channel. FIGURE 1. Beginning a New Channel Plan 1. In the PLN tab, click [Start Empty PLN] to get started. When you click this button, you will find that a few more tabs will pop up along the left-hand side of the program. FIGURE 2. 2. Navigate to the Left Toe, Right Toe and Center Line tabs and enter your channel limits (Figure 2). June / 2012 1 FIGURE 3. Generating the Channel File 3. Go back to the PLN tab and click [Generate CHN]. This will build the nodes which will be your channel coordinates thus creating a surface about your channel dimensions (Figure 3). FIGURE 4. Generating the Line File Create the Planned Lines for your Channel Design. a. Go to the Centerline Tab. b. Click [Calculate Chainage]. c. Enter your options for your planned lines, basins and toe points. d. Click [Generate LNW]. 5. In the Profiles tab, save the cross section lines. Click [Save LNW] and name your file. Your line file is now ready for running survey lines in the SURVEY program and for volumes calculations in the CROSS SECTIONS AND VOLUMES program . 4. 2 FIGURE 5. Saving the Line File FIGURE 6. The Final .LNW file in the HYPACK® Shell. Notice the template points have been created where the planned lines intersect the faces of the CHN file that the ADVANCED CHANNEL DESIGN program has been created based on your channel geometry. June / 2012 3