Appendix B – Communication Drivers
Ethernet TCP/IP
WAGO-I/O-PRO 32 Communication Drivers
Category:
Name:
Hardware:
Software:
Operating system:
Applicable to:
WAGO-I/O-PRO 32
TCP/IP communication
Ethernet_TCP_IP.dll
Network card for Ethernet
TCP/IP Network protocol (component part of Windows)
Windows 95, Windows 98, Windows 2000, Windows NT 4.0,
Windows XP
Programmable Ethernet Controller
Communication
parameters:
IP address
Range of value:
Comments:
[IP address],
[host name]
Port number
0 ... 65535
preferentially 2455
Transport protocol
udp, tcp
Debug level
16#0000...16#FFFF
The IP address of the host name is
entered here. „Localhost" can be used
for the own computer.
The syntax for an IP address is :
xxx.xxx.xxx.xxx
(e.g. 134.28.42.13).
Port number to be used for the
connection.
Generally the port number for the
WAGO-I/O system (2455) should be
used. If 2455 is not used then the port
number for dynamic connections in the
range 49152 ... 65535 should be used.
The range 0 ... 1023 is reserved for the
„well known" ports. The range 1024 ...
49151 is assigned manufacturer
specific.
Transport protocol to be used for the
TCP/IP communication. The transport
protocol UDP (User Datagram Protocol)
is used with udp. The TCP (Transport
Control Protocol) is used with tcp.
Set this Parameter to 0. The parameter
is only used for debugging.
Ethernet TCP/IP B-1
Ethernet TCP/IP
Graphic display:
Image B.1: Graphic display Ethernet TCP/IP
Function description:
Ethernet controllers can be programmed directly from a PC via TCP/IP. For this
purpose the Ethernet_TCP_IP.dll driver is used.
B-2 Ethernet TCP/IP
WAGO-I/O-PRO 32
Appendix B – Communication Drivers
System configuration:
Image B.2: System configuration Ethernet TCP/IP
WAGO-I/O-PRO 32
Ethernet TCP/IP B-3
B-4 Ethernet TCP/IP
WAGO-I/O-PRO 32