Supplies:
36 to 48 Orings 12mm (violet fuschia)
36 to 48 Orings 6mm (bright kiwi)
18 to 24 Jump Rings 16g 1/4” (royal blue shiny)
36 to 48 Orings 6mm (berry pink)
24 to 30 Jump Rings 18g 3/16” (green)
36 to 48 Orings 7.25mm (light turquoise)
Tools: 1 pair Flat Nose Pliers
1 pair curved needle nose pliers
1 pair long needle nose pliers
1. Use long needle nose pliers to pull 2
6mm orings onto 2 12mm orings. Place a 6mm
oring onto the pliers then grab the 2 12mm
orings with the pliers. Repeat this with
the second 6mm orings.
2. Open a 16g 1/4” jump ring. Pass the
jump ring through each side of the 12mm orings. Close jump ring.
3. Repeat steps 1 and 2 18 to 24 times depending on desired bracelet size.
4. Open 1 18g 3/16” jump ring. Pick up 1
7.25mm oring, pass through 12mm Oring, pick
up 6mm oring, pass through second 12mm oring and pick up 1 7.25mm oring. Close jump
ring.
5. Repeat step 4 linking the bottom of the
2 units that you joined in step 4.
6.Link another unit to the 2 units joined
in step 4 and 5. Open 1 18g 3/16” jump
ring. Pass through 7.25mm oring, pass
through 12mm oring, pick up 6mm oring,
pass through second 12mm oring and pick up
1 7.25mm oring. Close jump ring.
*in this step, you don’t pick up the first
7.25mm oring, you pass through the one
picked up in your previous row
7. Repeat step 6 linking the bottom of the
2 units that you joined in step 6.
8. Continue joining units together until you reach desired length.
9. Link starting and ending units together.
Open 1 18g 3/16” jump ring. Pass through
7.25mm oring, pass through 12mm Oring, pick
up 6mm oring, pass through second 12mm oring and pass through 7.25mm oring. Close
jump ring.
10. Repeat step 9 linking the bottom of
the starting and ending units together.