Introduction to
Topographic
Maps
Topographic Maps
• Two dimensional model of the Earth’s
surface (represents 3-D world)
• Topographic maps are also known as
contour maps.
• Show elevation above sea level using
contour lines.
“Real World”
Contour Map
Topographic Maps
• Contour Line –
- line on a map that connects points of EQUAL elevation.
- show elevation and shape of the land
• Relief – Difference between high and low elevations
Topographic Maps
• Contour Interval –
difference in elevation
between each line.
MUST be equal
spacing.
Contour interval =
20 feet
580
560
540
520
Topographic Maps
• Index Contour –
Usually every 5th line is printed darker and has
an elevation printed on it.
Rules for Contours
1. Contour lines never cross
Rules for Contours
2. Contours form closed loops (even if not
shown of the map.
Rules for Contours
3. Contours bend upstream (uphill) when
crossing a stream.
Rules for Contours
4.
The maximum possible
elevation for a hill is “1”
less than what the next
contour “should” be.
90
The highest possible
elevation of the hill is
just below the value
of the next line that is
not shown
80
70
60
50
399
179
239
Closely Spaced Contours
• Steeper Slope (Gradient) – contour lines are
closer together.
Wide Spaced Contours
• Gradual/Gentle Slope (Gradient) – contour lines
are farther apart.
A
B
Depressions
• Contour lines which show a depression,
crater, or sinkhole on a map.
• Shown by dashed lines (hachure marks)
on the inside of a contour line
• The elevation of the first depression
contour is the same as the lowest
regular contour near it.
Rules for Contours
The lowest possible
elevation for a
depression is “1” more
than what the next
contour “should” be.
90
90
80
The lowest possible
elevation of a
depression is just
above the value of the
next line that is not
shown
51
70
60
50
100
100
50
Benchmarks
• a location whose
exact elevation is
known and is noted
on a brass or
aluminum plate.
• bench marks are
shown on maps by an
X with the letters BM
written next to them.
Map Scales
• Indicates the distance on the map compared to
distance in the real world
• Graphical - by a line divided into equal parts and
marked in units of length.
Map Scales
• Numerically – usually by writing a fraction
to show what part of the true distances
map distances really are.
• 1:63,360
• One inch on the map equals 63,360
Inches in the real world.
(There are 63,360 inches in a mile)
Gradient
• The slope between any two points on a hill
• Gradient =
Change in Field Value
Distance
Gradient
• A trail is four miles long as measured by
the scale on a map. The beginning of the
trail is at the 1,060 ft contour line and the
end of the trail is at the 960 ft contour line.
Calculate the gradient of the trail.
Gradient =
1060 ft – 960 ft
4 miles
= 25.0 ft/mi
Gradient
Contour Interval = 20 ft
200
0
2
4
miles
6
8
10