Digital Output
Max 30VDC, 500mA
DC Relay Supply
+ -
+ -
Aerial Installation
WEATHERPROOF
CONNECTORS WITH
“3M 23” TAPE
1.
DIO channels can be
wired as either inputs or
outputs.
2.
All I/O must be SELV.
COAXIAL CABLE
ANT
DIO12
MAST
PROVIDE GOOD
GROUND
CONNECTION TO
MAST, MODULE
AND SURGE
ARRESTOR
RADIO TELEMETRY MODULE
DIO3
DIO2
DIO1
COM
I/0
DI 4
DI 3
DI 2
DI 1
GND
SUP1
SUP2
SUP2
EARTH STAKE
IF GROUND CONDITIONS ARE
POOR, INSTALL MORE THAN
SUP1
INPUTS
INSTALL AERIAL ABOVE
LOCAL OBSTRUCTIONS
DIO6
GND
CAUTION!
For continued
protection against
risk of fire, replace
the module fuse only
with the same type
and rating
DIO5
105U
STRESS RELIEF LOOP
xxxx-4
DIO4
SURGE
ARRESTOR
(OPTIONAL)
I/0
NOTES
1m minimum
COLINEAR
ANTENNA
DIO11
DIO9
OUTPUTS
DIO10
DIO8
DO 4
DO 3
DO 2
DO 1
DIO7
DC Load
2A
GND
PLEASE REFER TO THE USER MANUAL FOR IMPORTANT
REGULATORY AND SAFETY INFORMATION PRIOR TO
INSTALLATION AND USE OF THIS PRODUCT
DO NOT DISCONNECT
WHILE CIRCUIT IS LIVE
UNLESS AREA IS
KNOWN TO BE NON
HAZARDOUS
o 12 Amphour for AC/DC
o 100 Amphour for Solar
BAT+
IMPORTANT NOTICE
11-15VDC Supply or 12V
Backup Battery Required
SOL
EXPLOSION HAZARD
SOL
Installation Guide
12V Solar Panel
Supply max 20VDC
max 30W panel
GND
WARNING !
COM
105U-4-5W
ANTENNA INSTALLATION
Antennas should be installed by experienced contractors.
105U-4-5W Installation
Power supply:
(A) 12-24VAC 2.0 Amp CSA Certified Class 2
(B) 15-30VDC 2.0 Amp CSA Certified Class 2
(C) Supply battery or 11-15VDC
(D) Solar panel with solar battery
AC Supply 12-24VAC
min 15VAC for Battery
Charging.
Do not earth SUP1 or
SUP2 connections
+ DC Supply
15-30VDC
min 17VDC
for Battery
Charging
Digital Input
Voltage Free
Contact
OR
Transistor
Device
To Earth
Connection
Choose option and wire as shown
© ELPRO Technologies Pty. Ltd. 2006 Rev. 1.0