Gavilan College AMT 110 Aircraft Metal Structural Repair Worksheet #2

advertisement
Name:
Date:
Gavilan College AMT 110
Aircraft Metal Structural Repair
Worksheet #2
1. The most common type of rivet used in aircraft construction is
The most common rivet head shape used in aircraft construction are:
2.
3.
4. The most common rivet material used is
5. The nickname for rivets that are annealed and stored in a freezer is
6. Rivet diameter is measured in
7. Rivet length is measured in
The two elements that make up a rivet’s length are:
8.
9.
10. A rivet’s grip length is equal to
11. The formula for the amount of material needed to form a rivet shop head is
The two stresses applied to a rivet are:
12.
13.
14. The formula to determine a rivet diameter is
Rivet edge distance:
15. Minimum:
16. Maximum:
17. Rivet pitch is
Rivet pitch:
18. Minimum:
19. Maximum:
20. Rivet transverse pitch is
21. Rivet transverse pitch is usually equal to
22. The minimum rivet transverse pitch is
23. What is used to trim a rivet’s length?
24. A tool used to cut a cone-shaped depression is a
Page 1 of 2
Points: 40
25. The aviation standard countersink angle is
26. What type of countersink has adjustable cutting depth?
27. The component of a rivet gun that contacts the rivet is a
28. When adjusting the air pressure, a rivet gun should be tested against a
29. A rivet gun that is too power full is
may
and
.
30. A rivet gun that is too light may
31. A microshaver is used if
Recommended drill bit sizes:
32. #3 rivet:
33. #4 rivet:
34. #5 rivet:
Two methods of countersinking:
35.
36.
37. The male dimpling die for coin dimpling is a
38. A (dimpled or non-flush) type joint is stronger.
39. Hot dimpling is used to ensure
40. When extracting a rivet, you drill how far?
Page 2 of 2
Download