4 3 DWG.NO. . BOARD's FHS D Note 11 4.724 1 1 REV. A HOLE SCHEDULE COUNT PLATED .009 4229 YES .0236 .410 YES .04015748 . SH 2815 COMMENT 8 YES .041 . 52 YES 3 .057 . 8 YES 6 6 .059055118 . 1 NO .078740157 . 4 NO .078740157 . 1 YES .106 . .16692913 . 2 0.095" +/-.008" YES 8 YES 1. 2. 3. 4. 5. Signal 5 6 6 7. Signal 7 6. Ground 3 8. Ground 5 3 9. Ground 6 6 6 10. Signal 8 11. Ground 4 12. Signal 6 13. Power 2 6 6 14. Signal 3 15. Ground 1 3 C 6.181 Signal 1, Top Ground 2 Signal 2 Power 1 6 6 6 6 Note 12 D Layer Order: [mils] Note 10 16. Signal 4, Bottom C Board Characteristics: 16-Layer Board 0. All dimension in inches unless specified otherwise. 1. Material: FR4, Tg > 170 C. 9.183 2. Board Thickness: 0.095"+/-0.008" 3. Minimum Trace Width 0.005" Minimum clearrence 0.004" on all signal layers. 4. 1 oz Copper for top, bottom and power layers; 1/2 oz Copper for embedded signal layers. 5. Electroless Nickel/Immersion Gold plating; apply solder mask. min 25 um Cu, 2.5-5 um Ni, 0.05-0.2 um Au (Electroless Ni/Immersion Au). 6. Silkscreen on Both Sides .502 Note 12 7. Interlayer spacing : as specified. 8. FHS tolerances : +/- 0.003" unless specified otherwise. 9. Impedance 50 Ohm B for all 5-mil traces B 10. This is a pressfit tech. thru hole with the following specs: - Diameter of drilled hole: 0.7mm +/-0.02mm - Diameter of finished plated through hole: 0.6 mm +/-0.05mm Note 11 .768 - Hole Plating: min 25 um Cu, 2.5-5 um Ni, 0.05-0.2 um Au (Electroless Ni/Immersion Au). 11. 45 degree chamfer 12. Mill the Top and Bottom of Board on the Slder Side to a thickness of 0.063" +/- 0.008". 1.270 Width of the milled areas: 0.1" +0 / -0.05" .522 UNLESS OTHERWISE SPECIFIED CONTRACT NO. THE UNIVERSITY OF CHICAGO DIMENSIONS ARE IN INCHES TOLERANCES ARE: FRACTIONS DECIMALS ELECTRONICS DEVELOPMENT GROUP ANGLES .008 A APPROVALS . DATE TITLE DO NOT SCALE DRAWING DRAWN TREATMENT CHECKED M. Bogdan 5/8/13 H. Sanders 5/8/13 Dark Matter Search SIZE FINISH FSCM NO. ACT.WT CALC WT SCALE THIS SHEET IS COMPUTER GENERATED 4 3 DWG.NO. REV. 2815 ISSUED SIMILAR TO 2 A MUX Transition Board 1/2 SHEET 1 A 1 of 1