MECKLENBURG COUNTY Mechanical Equipment Replacement Declaration

advertisement
MECKLENBURG COUNTY
Code Enforcement
Mechanical Equipment Replacement
Declaration
Plans for Equipment Replacement may not be required provided that:
(9 the appropriate †)
†
No new electrical circuits or service change required.
†
No new extensions of existing electrical circuits required.
†
No changes in wire size required (increase).
†
No change in equipment load.
†
No duct changes except minor duct transition.
†
No alteration or addition of gas piping between service connection and gas cock.
†
†
No relocation of equipment, (i.e., exterior ground to roof, building interior to building
exterior, etc.).
No change in energy type, (i.e., electric to gas or fossil fuel, etc.)
†
No change in equipment BTU’s from existing to replacement.
†
New equipment complies with NC Energy Code (2002), Section 503.
The failure to 9 all of the † shall require the submission of plans to Code Enforcement
Commercial Building Permit Department for approval. This form serves for both the Mechanical
and Electrical permits on this change out project.
If you are uncertain on any of the above conditions, call CTAC (704-336-3829), Philip Edwards
(336-3555), or Gerald Harvell (336-3523) to confirm a “YES” or “NO” to your particular
installation.
To the best of my knowledge, ALL of the above information is accurate and complete. I
understand that any false statement may result in the revocation of this permit.
Signature:___________________________________Permit Number_____________________
Note: Inspector’s discretion may require contractor to present load calculations.
10/12/05
PEOPLE • PRIDE • PROGRESS
700 North Tryon Street • Charlotte, North Carolina 28202 • (704)336-2831 • Fax (704)336-3464
Download