For ConTech Lighting LED Linear Lighting Series: LPL
IMPORTANT SAFETY INSTRUCTIONS:
• Read all the instructions before installation. Save instructions for later use.
• Turn off power at fuse or circuit breaker box before installation or before doing any maintenance work.
• Do not exceed the nominal supply voltage or amperage rating.
• Do not install any lampholder closer than 6” from any curtain or similar combustible material.
• Warning: Risk of burns. Lamps are extremely hot when lit. Allow lamps to cool down in temperature before handling.
• Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in compliance with National Electrical Code and
local codes. Use of accessory equipment is not recommended.
• Installing contrary to instructions may cause unsafe conditions.
• Warning: Risk of fire. Most dwellings built before 1985 have supply wire rated at 60°C. Consult a qualified electrician before installation.
• To avoid hazards to children, account for all parts and properly dispose of all packing materials.
• Call the Technical Support department at ConTech Lighting with any installation questions: 847.559.5500.
JUNCTION BOX APPLICATION
Remove the junction box cover and open the wiring compartment
cover by removing the screw. After wiring, replace the cover.
Junction Box sold separately
Armored Cable (BX)
Jumper Cable to connect
to fixtures sold separately
Jumper Cable to connect
to fixtures sold separately
3/8" Miniature Die-Cast
Electrical Connector
Electrical Port
Cover (output)
Electrical Port
Cover Screw
Hardwire Power Cord
for UL1598
Junction Box application
Electrical port coves
must be isntalled in all
open ports at completion
of installation
Power Cord
for UL153
portable application
Fixture can be joined end-to-end by using
end-to-end connector supplied with fixture
FIXTURE MOUNTING
NOTE: Adjustable mounting brackets only pivot in one direction. Decide which directon is required and mount accordingly.
If pivot not tight enough: A) Use provided allen wrench to loosen set screw first
B) Then adjust tightness by using a screwdriver, then tighten the set screw
B
Hardwire Power Cord
for UL1598
Junction Box application
1. Draw a center line of the fixture
A
Mounting Brackets
2
Electrical Port
Cover Screw
Electrical Port
Cover (input)
Mounting Bracket Dimensions:
H= 0.94" W= 1.1" Adjustable angle 0- 90 degree
0.94"
3
1.08"
Power Cord
for UL153
portable application
0- 90 degree
1.1"
All specifications subject to change without notice.
1-847-559-5500
www.contechlighting.com
This document can be recycled.
LPL INST