PHOS LHC11h Pi0 production Henrik Qvigstad henrik.qvigstad@cern.ch Department of Physics @ University of Oslo 2012-11-14 1/7 I I I have started to write a macro to go from ’MakeMmixPi0.C’ to Production. I have used the output from ’MakeMmixPi0.C’ as it is on repo. I Take note that i have made some changes to this macro over the last couple of months, though these changes are just safeguards, they should not change behavior. I I have used GA_PbPb_output_8/ I All errors are those calculated in ’MakeMmixPi0.C’ propagated by TH1::Scale and TH1::Divide 2/7 I have made two types of plots, “Raw Production” and “production” Raw Production is I output of ’MakeMmixPi0.C’ simply normalized by dpt pt Production is I additional normalization by 2π, and I efficiency correction. Macro not currently on reop, will add after a little cleanup. 3/7 LHC11h, 0-10%, All, yr2 10-1 LHC11h, 0-10%, CPV, yr2 LHC11h, 0-10%, Disp, yr2 10-2 LHC11h, 0-10%, Both, yr2 T T (1/N ) dN/dp p (GeV/c)-2 Raw Production, PID=All, kCentral, cent=0 AA 10-3 10-4 10-5 10-6 10-7 2 4 6 8 10 12 14 16 18 20 pT (GeV/c) 4/7 π0 prod.yield, 0-5%, syst.error LHC11h, 0-10%, All, yr2 LHC11h, 0-10%, CPV, yr2 10 LHC11h, 0-10%, Disp, yr2 LHC11h, 0-10%, Both, yr2 t 1/Nevd3N/dyd2p (GeV-2c2) LHC10h, 0-5% 102 1 10-1 10-2 10-3 10-4 10-5 10-6 2 4 6 8 10 12 14 16 18 20 pT , GeV/c 5/7 T 1.8 LHC11h, 0-10%, CPV/All, yr2 1.6 LHC11h, 0-10%, Disp/All, yr2 LHC11h, 0-10%, Both/All, yr2 1.4 1.2 AA T (1/N ) d3N/dyd2p (GeV/c)-2 3 1 E d N (GeV/c)-2, PID=CPV, kCentral, cent=0 NAA dyd2p 1 0.8 0.6 0.4 2 4 6 8 10 12 14 16 18 20 pT (GeV/c) 6/7 of note I efficiency functions sent to me by Dmitri has discrepancy in used PID from macro he also sent. I root file with functions provide: I I "All", "Allcore", "Disp", "CPV", "CPVcore", "Both", "Bothcore" while macro uses: I "All", "Allcore", "Disp2", "Disp2core", "CPV", "CPVcore", "Both2", "Both2core" 7/7