GAF MATERIALS CORPORATION
MATERIAL SAFETY DATA SHEET
MSDS # 2045
MSDS DATE: 06/03
SECTION 1: PRODUCT AND COMPANY IDENTIFICATION
PRODUCT NAME:
EverGuard® EPDM Lap Sealant LVOC
CHEMICAL NAME/SYNONYM:
CHEMICAL FAMILY:
MANUFACTURER:
ADDRESS:
24 HOUR EMERGENCY
PHONE:
CHEMTREC PHONE:
PREPARED BY:
APPROVED BY:
EPDM Adhesive
Mixture
GAF Materials Corporation
1361 Alps Road, Wayne, NJ 07470
800-424-9300
800-424-9300
Bill Kuhn
Dan Helman
NFPA HAZARD RATING:
2
3
0
Health
Flammable
Reactive
Special Hazards
OSHA HAZARDOUS:
Health
Flammable
Reactive
Special Hazards
Yes
HMIS HAZARD RATING:
1
3
0
No
SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS
CHEMICAL NAME
Aliphatic Petroleum Distillates
COMMON NAME
Naphtha
CAS #
64742-47-8
% (BY WT)
<17
Silica, Crystalline, Quartz
Rose Quartz, Sand
14808-60-7
<1
EPA TSCA
Registered
>82
Nonhazardous as per 29
CFR 1910.1200.
None
EXPOSURE LIMITS
PEL 500 ppm
TLV 300 ppm (based on TLV for
VM&P Naphtha)
PEL (Respirable) 10 mg/m3
(% Si02 + 2)
PEL (Total)
30 mg/m3
(% Si02 + 2)
TLV (Respirable) 0.05 mg/m3
None Established
SECTION 3: HAZARDS IDENTIFICATION
PRIMARY ROUTE OF EXPOSURE:
SIGNS & SYMPTONS OF EXPOSURE
ACUTE HEALTH HAZARDS:
CHRONIC HEALTH HAZARDS:
CARCINOGENICITY:
PAGE 1 OF 5
Inhalation
Eye contact may cause eye irritation, redness, tearing and blurred vision. Prolonged or repeated
skin contact may cause irritation, dermatitis and drying of the skin. Inhalation may cause
respiratory system irritation and central nervous system depression (Narcosis) characterized by
headache, dizziness,
muscular weakness and fatigue. May cause unconsciousness if exposure is excessive.
N/a
Pre-existing lung, skin or nervous system disorders may be aggravated by exposure to this
material.
Silica, Crystalline, Quartz is classified as a NTP and an IARC Class 2A Carcinogen.
GAF MATERIALS CORPORATION
MATERIAL SAFETY DATA SHEET
MSDS # 2045
MSDS DATE: 06/03
SECTION 4: FIRST AID MEASURES
FIRST AID PROCEDURES:
NOTES TO PHYSICIANS OR FIRST AID
PROVIDERS:
If this material contacts the eyes, hold eyelids open and flush immediately with a gentle
stream of water for at least 15 minutes, preferably at an eyewash fountain. Get medical
attention. In case of skin contact, clean with rubbing alcohol first, followed immediately by
washing affected area with soap and water. In case of inhalation, remove to fresh
uncontaminated air. Administer oxygen if breathing is labored. Give artificial respiration if
breathing has stopped. Get medical attention immediately if oxygen or artificial respiration is
administered. In case of accidental ingestion, do not induce vomiting. Get medical attention
and advise the physician of the nature of the material.
N/a
SECTION 5: FIRE-FIGHTING PROCEDURES
Carbon Dioxide, dry chemical, alcohol foam or water fog. Do not use a direct
stream of water. Product will float and can be reignited on the surface of the water.
In the event of partial combustion, fumes, smoke, carbon monoxide, aldehydes,
and other decomposition products may be released.
Wear impermeable protective clothing and self-contained breathing apparatus.
Toxic fumes and vapors may be evolved.
Heat builds up pressure in closed containers. Cool with water stream. Invisible
volatile vapors from this product may settle in low areas or travel some distance
along the ground or surface to ignition sources where they may ignite or explode.
SUITABLE EXTINGUISHING MEDIA:
HAZARDOUS COMBUSTION PRODUCTS:
RECOMMENDED FIRE FIGHTING PROCEDURES:
UNUSUAL FIRE & EXPLOSION HAZARDS:
SECTION 6: ACCIDENTAL RELEASE MEASURES
ACCIDENTAL RELEASE MEASURES:
N/a
SECTION 7: HANDLING AND STORAGE
HANDLING AND STORAGE:
OTHER PRECAUTIONS:
STEPS TO BE TAKEN IN CASE MATERIAL IS
REALEASED OR SPILLED:
PRECAUTIONS TO BE TAKEN IN HANDLING
& STORAGE:
N/a
N/a
Remove ignition sources. Absorb on inert material. Use nonsparking tools. Place in secure
containers for disposal.
Keep away from heat, sparks, and open flames. Keep containers closed. Vapors of this
material are heavier than air and will collect in low or confined areas. Containers, even
those
that have been emptied, can contain explosive vapors. Do not cut, drill, grind, weld or
perform similar operations near containers. Static electricity may accumulate and create a
fire
hazard. Ground fixed equipment. Bond and ground all transfer containers and equipment.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
ENGINEERING CONTROLS:
VENTILATION:
RESPIRATORY PROTECTION:
EYE PROTECTION:
SKIN PROTECTION:
OTHER PROTECTIVE CLOTHING OR
EQUIPMENT:
WORK HYGIENIC PRACTICES:
EXPOSURE GUIDELINES:
PAGE 2 OF 5
N/a
Use in a well-ventilated location.
If personal exposure concentrations cannot be maintained below the appropriate
exposure limits using engineering controls, a NIOSH approved organic vapor air
purifying respirator may be appropriate based on employer-determined exposure
levels. Air supplied or SCBA respirators may be required when the measured
chemical concentration exceeds the capacity of the air purifying respirator or when
personal exposure levels are unknown.
Wear safety glasses with side shields or chemical splash goggles when using this
product.
Wear nitrile or polyvinyl alcohol gloves for direct handling.
Not required.
Wash exposed skin prior to eating, drinking and smoking and at the end of each work
shift. Wash contaminated clothing prior to reuse.
N/a
GAF MATERIALS CORPORATION
MATERIAL SAFETY DATA SHEET
MSDS # 2045
MSDS DATE: 06/03
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE & ODOR:
FLASH POINT:
METHOD USED:
EVAPORATION RATE:
pH (undiluted product):
Black paste with characteristic aliphatic solvent naphtha odor.
52°F
LOWER EXPLOSIVE LIMIT:
TCC
UPPER EXPLOSIVE LIMIT:
9.2 (Ethyl Ether=1)
BOILING POINT:
Unknown
MELTING POINT:
SOLUBILITY IN WATER:
<0.5%
PERCENT VOLATILE:
0.9%
6.7%
240°F
Not
Applicable
1.16
(Water=1)
<50%
WITHOUT WATER (LBS/GAL):
N/a
SPECIFIC GRAVITY:
3.8 (Air=1)
VAPOR DENSITY:
45 mm Hg @ 78° F
VAPOR PRESSURE:
VOLATILE ORGANIC COMPOUNDS (VOC)
N/a
WITH WATER (LBS/GAL):
N/a
MOLECULAR WEIGHT:
SECTION 10: STABILITY AND REACTIVITY
THERMAL STABILITY:
CONDITIONS TO AVOID (STABILITY):
STABLE
UNSTABLE
Avoid flames, sparks or other sources of ignition. Incompatible with acids, alkalies and strong
oxidizing agents.
N/a
INCOMPATIBILITY (MATERIAL TO
AVOID):
HAZARDOUS DECOMPOSITION OR BYPRODUCTS:
HAZARDOUS POLYMERIZATION:
N/a
Will not occur
_________________________________________________________________________________________________________________
SECTION 11: TOXICOLOGICAL INFORMATION
TOXICOLOGICAL INFORMATION:
N/a
SECTION 12: ECOLOGICAL INFORMATION
ECOLOGICAL INFORMATION:
N/a
_________________________________________________________________________________________________________________
SECTION 13: DISPOSAL CONSIDERATIONS
WASTE DISPOSAL METHOD:
RCRA HAZARD CLASS:
PAGE 3 OF 5
N/a
N/a
GAF MATERIALS CORPORATION
MATERIAL SAFETY DATA SHEET
MSDS # 2045
MSDS DATE: 06/03
SECTION 14: TRANSPORT INFORMATION
U.S. D0T Highway
Transportation
PROPER SHIPPING NAME:
HAZARD CLASS:
ID NUMBER:
PACKING GROUP:
LABEL STATEMENT:
OTHER REQUIREMENTS:
U.S. DOT Water
Transportation
Adhesives, 3, UN1133, II
3
UN 1133
Flammable Liquid
49 CFR 172.101 Adhesives, UN1133, IMDG Class 3.2, Pg. 3174, Flash
Point –10C.
PROPER SHIPPING NAME:
HAZARD CLASS:
ID NUMBER:
PACKING GROUP:
LABEL STATEMENT:
U.S. DOT Air Transportation
PROPER SHIPPING NAME:
HAZARD CLASS:
ID NUMBER:
PACKING GROUP:
LABEL STATEMENT:
OTHER REGULATORY
AGENCIES
PROPER SHIPPING NAME:
HAZARD CLASSIFACTION:
ID NUMBER:
LABELS REQUIRED:
OTHER REQUIREMENTS:
SECTION 15: REGULATORY INFORMATION
U.S. FEDERAL REGULATIONS:
TSCA (TOXIC SUBSTANCE CONTROL ACT):
CERCLA (COMPREHENSIVE RESPONSE
COMPENSATION, AND LIABILITY ACT):
SARA TITLE III (SUPERFUND AMENDMENTS AND
REAUTHORIZATION ACT):
311/312 HAZARD CATEGORIES:
313 REPORTABLE INGREDIENTS:
N/a
N/a
N/a
N/a
N/a
N/a
_________________________________________________________________________________________________________________
SECTION 16: OTHER INFORMATION
ADDITIONAL COMMENTS:
DATE OF PREVIOUS MSDS:
CHANGES SINCE PREVIOUS MSDS:
TELEPHONE NUMBER FOR ADDITIONAL
INFORMATION:
PAGE 4 OF 5
Although Firestone Building Products Company has no control over the customer’s method
of using this product, under the conditions of normal use the Silica, Crystalline, Quartz
contained in this product is a completely incorporated component, and, therefore, should not
present an inhalation hazard.
10/02
Phone Numbers
800-766-3411
GAF MATERIALS CORPORATION
MATERIAL SAFETY DATA SHEET
PAGE 5 OF 5
MSDS # 2045
MSDS DATE: 06/03