IBRACON Structural and Materials Journal - Instituto Brasileiro do Concreto
1
Submission format
Title
Abstract
Text with maximum of 10 lines or 300 words written in English. The abstract must supply the reader
with a clear idea of the subject treated in the paper. The abstract should be a concise statement of the
principal paper’s findings and conclusions.
Keywords: maximum of five keywords.
1
Introduction
State of the art, objectives, justification for this work and the significance are to be reviewed
here. The organization suggestion has been adjusted to papers on experimental investigations,
however, the authors can freely modify the sequence of items.
The maximum number of text pages (including acknowledgements and references) of this
manuscript is 25.
Figures, tables and references should be numbered consecutively in square brackets [1], and list
the last name of the authors (Cox [1]).
1.1
Justification
If it is necessary, one can provide subtitles to clarify the text.
2
Materials and experimental program
Present the physical, chemical and mechanical characterization of the materials used in the
experimental program. Describe the laboratory investigations and procedures.
Tables and figures must be numbered consecutively and referred to in the text. All tables and
figures must have captions and should accompany the manuscript, but should not be included
within the text. They are shown on separate pages at the end of this manuscript.
2
3
Results and discussions
The results need to be discussed to support the conclusions.
4
Conclusions
Write a set of conclusions, or a summary in which the significant implications of information
presented in the paper body are reviewed.
5
Acknowledgements
If the author(s) wishes to recognize any individuals, organizations, or agencies for assistance or
support for the reported work.
6
References
[1] Cox HL. The elasticity and strength of paper and other fibrous materials. British Journal of
Applied Physics, v.3, n.1, 1952; p.72-79.
[2] TAYLOR, H. F. W. Cement Chemistry, London: Thomas Telford, 2ed, 1997, 459 p.
[3] International Union of Pure and Applied Chemistry – IUPAC. Manual of Symbols and
Terminology, Appendix 2, Part 1, “Colloid and Surface Chemistry”, Pure Applied
Chemistry, n.31, p.578, 1972.
[4] BROWN, P. W. The implications of phase equilibria on hydration in the tricalcium silicatewater and the tricalcium aluminate-gypsum water systems. In: Congresso Internacional da
Química do Cimento, 8o, Rio de Janeiro, 1986, Anais, Rio de Janeiro, 1986, v.3, p.231-38.
3
TABLES
All data shown in tables must be typed using 10 or 11 points. Table 1 is an example of this situation.
Each table should be presented in a separate page.
Table 1 Probably composition of lime hydrated.
Determination
Mass (%)
Ca(OH)2
Mg(OH)2
CaSO4
CaCO3
SiO2
Al2O3+Fe2O3
Water
91,00
0,56
0,49
5,60
1,50
0,89
0,32
4
FIGURES
Photographs, charts and diagrams are all to be referred to as "Figure(s)". All illustrations
should be clearly and suitable for reproduction in black and white. Colors figures are not
recommended. All data shown in figures must be typed equal to text.
Each figure should be presented in a separate page.
Teórico (mmol/L)
10000
1000
100
10
sódio
potássio
1
0.1
0.1
1
10
100
1000 10000
Medido (mmol/L)
Figure 1. Relation between the measured concentration and the theoretical concentration of ions
alkaline.
5
AUTHORS’ IDENTIFICATION.
The authors’ photos can be omitted, however, if one photo is omitted all of them must be as
well.
Photo
(2 x 1,8 cm)
T. N. BITTENCOURT a, G. MELO b
a
Institute, Department, University, Company, e-mail, address, city, country
b
Institute, Department, University, Company, e-mail, address, city, country