SEMESTER 2 Chapter 7
RIPv2
V 4.0
7.0.1.1
7.1.1.3
7.1.1.4
7.1.2.1
7.1.2.2
7.1.3.1
7.1.3.3
7.1.4
Why has RIP lost favor as
opposed to other protocols?
When is RIP a desirable
protocol?
What are the enhanced
features of RIPv2?
What do both versions of RIP
share in features and
limitations?
What type of address must be
used when a packet is sent
outside your private network?
What subnet mask is used
when only two ip addresses are
needed?
What is a loopback interface?
What is a loopback address
used for in the lab setting?
What is the command to
establish a supernet route?
What does a supernet route do
to the routing table?
What are the two
characteristics of a null
interface?
What happens to traffic sent to
a null interface?
What command will send a
route to other routers in the
network?
What is the first command to
check network connectivity?
What should the result of the
above command show?
What is the second command
to use to check connectivity?
What is not included in a RIPv1
message?
What happens is RIP has two
routes to the same network?
Why doesn’t R2 include the
route to 172.30.0.0/24 to either
routers?
What are the two methods
7.1.5.1
7.2.1.1
7.2.1.2
7.2.2.1
7.2.3.1
7.2.4.1
7.3.1
7.3.2
7.4.1
RIPv1 uses to determine the
subnet mask for an ip address?
Why is the route 192.168.0.0
/16 not included in the routing
updates from R2?
What subnet mask would allow
this route to be included in the
routing updates?
What type of packet is a RIPv2
encapsulated in?
What port number does it use?
How many routes can be
included?
What are the two extensions
added to RIPv2?
What does a router running
RIPv1 do with a RIPv2 update?
What command is used to
modify the version of RIP being
used to version 2?
What command can be used to
revert back to version 1?
What is the new route included
in the routing table?
Why is the only route in the
table 172.30.0.0/16 used?
What is the command to turn
off autosummarization?
What is different in the show ip
protocols display?
What has been added to the
routing tables?
What happens when a route is
incremented?
What type of address is being
used for routing updates?
What is the advantage of using
the above type of address?
How does RIPv2 determine the
subnet mask for a route?
What is one of the goals of
CIDR?
What is a supernet?
What is a characteristic of a
supernet’s subnet mask?
Where should you start when
troubleshooting? List them.
What will the show ip route
command verify?
7.4.2
7.4.3.1
What will the show ip interface
brief command verify?
What will the show ip protocols
command verify?
What will the debug ip rip
command verify?
What will the ping command
verify?
What will the show runningconfig command verify?
What is considered a good
place to begin when
troubleshooting RIPv2?
What 2 things does the network
command do?
What is the final command
listed to check for?
What is a security concern for
routing updates?
What are the three methods of
receiving an invalid update
listed?
What is listed as a good
practice when configuring a
routing protocol?