67520-System Bootstrap
advertisement
System Bootstrap, Version 12.1(3r)T2, RELEASE SOFTWARE (fc1) Copyright (c) 2000 by cisco Systems, Inc. PC = 0xfff0ab6c, Vector = 0x500, SP = 0x680127c0 C2600 platform with 131072 Kbytes of main memory program load complete, entry point: 0x80008000, size: 0x861b00 Self decompressing the image : ################################################# ######PC = 0xfff0ab6c, Vector = 0x500, SP = 0x87fff8b0 monitor: command "boot" aborted due to user interrupt rommon 1 > System Bootstrap, Version 12.1(3r)T2, RELEASE SOFTWARE (fc1) Copyright (c) 2000 by cisco Systems, Inc. C2600 platform with 131072 Kbytes of main memory program load complete, entry point: 0x80008000, size: 0x861b00 Self decompressing the image : ################################################# ######################################################################## ######## ############## [OK] Smart Init is enabled smart init is sizing iomem ID MEMORY_REQ TYPE 0001C1 0X000B3B80 C2600 Single Fast Ethernet 0X00098670 public buffer pools 0X00211000 public particle pools TOTAL: 0X0035D1F0 If any of the above Memory Requirements are "UNKNOWN", you may be using an unsupported configuration or there is a software problem and system operation may be compromised. Rounded IOMEM up to: 4Mb. Using 3 percent iomem. [4Mb/128Mb] Restricted Rights Legend Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c) of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013. cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706 Cisco Internetwork Operating System Software IOS (tm) C2600 Software (C2600-IX-M), Version 12.3(22), RELEASE SOFTWARE (fc2) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2007 by cisco Systems, Inc. Compiled Wed 24-Jan-07 16:48 by ccai Image text-base: 0x80008098, data-base: 0x80EE0DB4 cisco 2650 (MPC860P) processor (revision 0x200) with 126976K/4096K bytes of memo ry. Processor board ID JAB05080D0A (1693012601) M860 processor: part number 5, mask 1 Bridging software. X.25 software, Version 3.0.0. 1 FastEthernet/IEEE 802.3 interface(s) 32K bytes of non-volatile configuration memory. 32768K bytes of processor board System flash (Read/Write) --- System Configuration Dialog --Would you like to enter the initial configuration dialog? [yes/no]: System Bootstrap, Version 12.1(3r)T2, RELEASE SOFTWARE (fc1) Copyright (c) 2000 by cisco Systems, Inc. C2600 platform with 131072 Kbytes of main memory PC = 0xfff0ab6c, Vector = 0x500, SP = 0x80004394 monitor: command "boot" aborted due to user interrupt rommon 1 > 0 monitor: command "0" not found rommon 2 > System Bootstrap, Version 12.1(3r)T2, RELEASE SOFTWARE (fc1) Copyright (c) 2000 by cisco Systems, Inc. C2600 platform with 131072 Kbytes of main memory program load complete, entry point: 0x80008000, size: 0x861b00 Self decompressing the image : ################################################# ######################################################################## ######## ############## [OK] Smart Init is enabled smart init is sizing iomem ID MEMORY_REQ TYPE 0001C1 0X000B3B80 C2600 Single Fast Ethernet 0X00098670 public buffer pools 0X00211000 public particle pools TOTAL: 0X0035D1F0 If any of the above Memory Requirements are "UNKNOWN", you may be using an unsupported configuration or there is a software problem and system operation may be compromised. Rounded IOMEM up to: 4Mb. Using 3 percent iomem. [4Mb/128Mb] Restricted Rights Legend Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c) of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013. cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706 Cisco Internetwork Operating System Software IOS (tm) C2600 Software (C2600-IX-M), Version 12.3(22), RELEASE SOFTWARE (fc2) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2007 by cisco Systems, Inc. Compiled Wed 24-Jan-07 16:48 by ccai Image text-base: 0x80008098, data-base: 0x80EE0DB4 cisco 2650 (MPC860P) processor (revision 0x200) with 126976K/4096K bytes of memo ry. Processor board ID JAB05080D0A (1693012601) M860 processor: part number 5, mask 1 Bridging software. X.25 software, Version 3.0.0. 1 FastEthernet/IEEE 802.3 interface(s) 32K bytes of non-volatile configuration memory. 32768K bytes of processor board System flash (Read/Write) --- System Configuration Dialog --Would you like to enter the initial configuration dialog? [yes/no]: enable % Please answer 'yes' or 'no'. Would you like to enter the initial configuration dialog? [yes/no]: no Press RETURN to get started! *Mar 1 00:00: Router>enable Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)#configure terminal^Z ^ % Invalid input detected at '^' marker. Router# *Mar 1 00:10:15.656: %SYS-5-CONFIG_I: Configured from console by console Router#configureterminal^Z Translating "configureterminal"...domain server (255.255.255.255) Translating "configureterminal"...domain server (255.255.255.255) (255.255.255.255) Translating "configureterminal"...domain server (255.255.255.255) % Unknown command or computer name, or unable to find computer address Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)#interface ethernet 0 ^ % Invalid input detected at '^' marker. Router(config)#interfaace ethernet 0^Z % Invalid input detected at '^' marker. ^ Router# *Mar 1 00:15:19.626: %SYS-5-CONFIG_I: Configured from console by console Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)#interface ethernet 0 ^ % Invalid input detected at '^' marker. Router(config)#interface ethernet 0^Z % Invalid input detected at '^' marker. ^ Router# *Mar 1 00:17:14.859: %SYS-5-CONFIG_I: Configured from console by console Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)#interface ethernet 1 ^ % Invalid input detected at '^' marker. Router(config)#interface ethernet0 ^ % Invalid input detected at '^' marker. Router(config)# Router con0 is now available Press RETURN to get started. *Mar 1 00:29:06.390: %SYS-5-CONFIG_I: Configured from console by console Router(config)#interface fa0 % Incomplete command. Router(config)#conf interface fa0 ^ % Invalid input detected at '^' marker. Router(config)#conf t ^ % Invalid input detected at '^' marker. Router(config)#config t interface fa0 ^ % Invalid input detected at '^' marker. Router(config)#conf t interface fa0 ^ % Invalid input detected at '^' marker. Router(config)#config terminal interface fa0 ^ % Invalid input detected at '^' marker. Router(config)#interface fa0 *Mar 1 00:00:07.868: %PARSER-4-BADCFG: Unexpected end of configuration file. *Mar 1 00:00:08.060: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state t o up *Mar 1 00:00:09.062: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthern et0/0, changed state to up *Mar 1 00:00:22.880: %IP-5-WEBINST_KILL: Terminating DNS process *Mar 1 00:01:02.353: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from (t ftp://255.255.255.255/network-confg) failed *Mar 1 00:01:43.360: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from (t ftp://255.255.255.255/cisconet.cfg) failed *Mar 1 00:02:44.376: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from (t ftp://255.255.255.255/router-confg) failed *Mar 1 00:03:14.377: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from (t ftp://255.255.255.255/network-confg) failed *Mar 1 00:03:25.383: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from (t ftp://255.255.255.255/ciscortr.cfg) failed *Mar 1 00:03:25.383: %SYS-5-RESTART: System restarted -Cisco Internetwork Operating System Software IOS (tm) C2600 Software (C2600-IX-M), Version 12.3(22)
