Zinc paste
Batch quantity 1000 g
Prepared by:
Preparation date:
Batch number:
Raw materials and packaging materials
Quantity
prescribed
Zinc oxide
500 g
Petrolatum
500 g
Master manufacturing formula
approved by
Source master manufacturing
formula: Dermatological
preparations for the tropics, 2nd ed.
Source and
batch number
Actual quantity
weighed/measured
Initials weighing
Initials control
In-process checks
Sieved?
yes/no
Homogeneous?
yes/no
Container(s) with wide opening
Preparation
1. If sieves are available, sieve the zinc oxide, preferably through a 90 μm sieve.
2. Melt the petrolatum over gentle heat.
3. Triturate the zinc oxide carefully with the molten petrolatum.
4. Mix until no zinc oxide aggregates are left and the preparation is homogeneous.
2012 jfmamjjasond 2013 jfmamjjasond 2014 jfmamjjasond 2015 jfmamjjasond 2016 jfmamjjasond 2017 jfmamjjasond
Storage condition no specific conditions required
Shelf life
2 years
Expiry date
Yield
Loss
Loss due to
End controls before release of batch
Batch numbers raw materials correct?
Packaging materials correct, in good condition and closed properly?
Labelling conform model?
Expiry date stated correctly?
Homogeneous paste without zinc oxide aggregates?
Are all boxes of this form filled correctly and completely?
Checked by
Result
Batch released by (name and
signature)
Date:
Model of label for stock
Model of label for the patient
For external use only
Zinc paste
Batch number and batch date
Do not use past: (production date + 2 years)
For external use only
Dispensing unit and date
Zinc paste _____ g
Patient name
Apply several times daily.
To remove zinc paste from the skin, rinse with some vegetable
oil before using water and soap.
Do not use past (dispensing date + 3 months)