EHS Revised Jan 2014
GENERAL SAFETY TEST
General safety training and its associated test must be completed on an annual basis by those whose job
solely consists of administrative or office type tasks and who work in the cleanrooms or laboratories. In order to
document your understanding of this training please complete this test, save it and email as an attachment to
CNSEEHS@albany.edu
YOU MUST GET AT LEAST AN 80% TO PASS THIS TEST
Do you work in maintenance, equipment/facility engineering, with any chemicals and/or gases or
generate hazardous waste?
Yes
No
If Yes, you must also attend a classroom session of Advanced Safety training class annually. Please go to the
CNSE intranet for training dates, times and locations and email CNSEEHS@albany.edu to sign-up for the
next Advanced Safety training class.
Name:
Date:
Email Address:
Employer:
Supervisor:
Department/Building Location:
1. If you slip, fall or injure yourself you should:
a.
b.
c.
d.
Do nothing as long as the pain isn’t too bad.
Call Security at 437-8600
File Workers Compensation Reserve Form
Apply a cold pack and notify your manager within 48 hours
2. How do you report an emergency on the CNSE campus?
3. What should you do if you see or hear the TGMS alarm in NFN?
a.
b.
c.
d.
Immediately proceed to your Rally Point
Call your Supervisor for direction
Immediately proceed to the CESTM rotunda
Go to lunch
4. A Fire Evacuation has been activated. You know it is a Fire Alarm since you:
a.
b.
c.
d.
Hear an Intermittent Tone and see Blue Flashing Lights
Hear an Intermittent tone and see White Flashing Lights with a voice enunciation
Hear a Solid Tone and see Flashing Red Lights
See Flashing Blue Lights over the phones in the parking lot
5. What is the procedure for ordering chemicals? (Check all that apply)
a.
b.
c.
d.
e.
Check the CNSE Approved Chemical list for the chemical you need to purchase.
Get the SDS from the supplier.
Fill out a chemical authorization request for each new chemical and submit with SDS to EHS.
Answer any EHS questions on the location of use, handling procedures and storage requirements.
Contact purchasing to get the chemical ordered.
GENERAL SAFETY TEST
EHS Revised Jan 2014
6. Safety Data Sheets: (Check all that apply)
a.
b.
c.
d.
Provide information on the composition of a chemical
Give useful instructions on how to handle a chemical exposure or chemical spill
Are developed by the individual who purchases the chemical from the supplier
Advise an individual to store the chemical near incompatibles
7. Match the following pictograms with their associated hazard: (enter number in space next to category)
1.
Flammables
2.
Corrosive
3.
Irritant
4.
Acute toxicity (category 1)
8. What elements are contained on a GHS Label? (Check all that apply)
a.
b.
c.
d.
e.
Signal Word
Precautionary Statements
Hazard Statements
Pictograms
Supplier Information
9. Where can you find information on the CNSE EHS policies, training schedule,
Approved Chemical list and procedures?
10. Job Hazard Assessments for your area: (Check all that apply)
a.
b.
c.
d.
Can be viewed by contacting your supervisor
Consist of a breakdown of the tool, process, experiment or activity
Identify controls that need to be implemented to increase risk and hazards
Rank risks from high (unlikely to cause harm) to low (likely to cause harm)
11. You can work alone in all cleanrooms and labs.
T
F
12. What is the purpose of an exit sign? (check all that apply)
a.
b.
c.
A way to designate the location of an exit
A way to guide you to the means of egress
Neither of the above
13. An extension cord along with a GFCI adapter is only for temporary use. T
F
14. When are you allowed to block an electrical panel?
15. All ladders should be: (Check all that apply)
a.
b.
c.
d.
Secured
Extended at least 5ft above a landing
Angled using the 3:1 rule
Placed on a level surface
16. All high powered lasers (class 3B and 4) must be
to prevent injury and exposure.
17. Radiation surveys need to be performed _
__on radiation producing equipment at CNSE
and have _
__ to recognize areas where there’s radiation producing equipment.
a.
Annually; signage saying “Caution-Radiation Area, Authorized Personnel Only”
GENERAL SAFETY TEST
EHS Revised Jan 2014
b.
c.
Only during initial install; safety glasses
Annually and after any maintenance, removal of shielding or equipment modifications; signage saying
“Caution-Radiation Area, Authorized Personnel Only”
d.
Monthly; signage saying “Caution
18. If a radiation producing device or source is moved or relocated, the Radiation Safety Officer
(RSO) must be notified:
a.
b.
c.
d.
They never need to be notified
Only if it leaves the lab or cleanroom
Every time regardless of distance
Only before disposal
19. Identify hazards associated with a cryogenic liquid? (Check all that apply)
a.
b.
c.
d.
e.
Frostbite
Damage to equipment
Asphyxiation
Oxygen enrichment
Pressurization and explosion
20. When transporting cryogenic material in an elevator you must: (Check all that apply)
a.
b.
c.
d.
e.
Ride in the elevator with the material
Meet the elevator at its destination or have someone else assist you
Make sure no one is in the elevator including yourself
Make sure the material is secure to prevent spills
Handle the cryogenic dewar cylinder with a handcart, by rolling it, by pulling it or on a pallet
*Once you complete the test, save it and email as an attachment to CNSEEHS@albany.edu