Technical data sheet Cod STP BLEACH FOR WOOD Production date: 31/08/1999, revision 1 date: 6/6/2001 _______________________________________________________________________ PRODUCT: SB10A BLEACH FOR WOOD DESCRIPTION: bicomponent product, ideal for bleaching all wooden surfaces without the need for rinsing and without altering the wood’s fibres. It contains caustic soda and oxygenated water. The product is corrosive. USE: all untreated wooden surfaces APPLICATION: by brush or by spray (low pressure) HARDENER: SB10B at 50% DILUTION: with water REACTION TIME: 3 hours. This time also depends on atmospheric conditions and refers to the time of maximum efficiency of the product. After 3 hours the bleach is no longer efficient. DRYING: after 72 hours it is possible to coat the bleach with acrylic or water based products. It is advisable to lightly sand before coating. METRIC YIELD: 50 g/m2 (this is approximate, as it varies depending on the type of wood and application). PHYSICAL AND CHEMICAL PROPERTIES physical state: colourless liquid shelf life at 20°C: 9 months if protected from direct light sources specific gravity: 1.1 – 1.2 kg/l flash point: non-flammable Always verify the suitability of the product for the job to be done before application. We can not accept responsibility for the outcome. This technical data sheet is an official document of ICA S.p.a. There is no personal signature on it because it is issued by an automatic system.