Katch Mat™ Measurement Sheet This is a measurement worksheet for a Rotary Table. Check your measurements by adding together (A) + (B) + (C) MUST equal dimension (F). (B) + (D) + (E) MUST equal dimension (G). Drilling Contractor: ______________________ RIG #: __________ RIG Manager: ____________________ Telephone: ______________________ Fax: ________________________ 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. Table Make & Model: _________________________________________ Is the Rotary Table elevated above surrounding floor? Yes / No Mark all table locks, oil level checks and any obstructions that require mat to be cut out Do you operate with an Iron Roughneck? Yes / No Does your floor drain around the perimeter of the Rotary Table? Yes / No If No, please indicate areas of draining on drawing Do you need Splash Guard? Yes / No Color for the extra section you want to cover (please identify the colors on the drawing) a. Yellow b. Green (safe zone) c. Red Please identify on the drawing if need: a. Transition border b. 1” Burm c. 4” Wall Do you need to cover your Set Back area with Stab Mat? Yes / No If Yes, please choose which color do you need and identify direction a. Red ____ Vertical ____ b. Yellow ____ Horizontal ____ Do you need Stair Tred Katch Mat to cover the stairs? Yes / No If Yes, please indicate: a. Quantity b. Length c. Width NOTE: Katch Kan will provide you with a drawing for your approval prior to fabrication Measurements : A.________ B.________ C.________ D.________ E.________ F.________ G.________ H.________ I.________ J.________ K.________ L.________ M.________ N.________ O.________ P.________ Q.________ R.________ S.________ T.________ U.________ V.________ W .________ X1._______ X2._______ Y1._______ Y2._______ Z.________