To send e-mail, you must specify the name of the sender.
You can specify the e-mail sender by any of the following methods:
[+] Selecting a Sender from the List
[+] Using a Registration Number to Specify a Sender Name
[+] Selecting the Sender by Searching Address Book of the Device
Note:




Senders must be registered in advance under [System Settings].
In [System Settings], you can specify e-mail address of the administrator as the default
sender name. This lets you send e-mail without entering anything for [Sender Name].
Depending on the security setting, the logged-on user may be specified as [Sender
Name].
When a protection code has been set, a screen for entering the protection code appears
after selecting the sender. Enter the protection code, and then press [OK]. If the
protection code you entered is correct, the sender name is displayed.