Safety Data Sheet in accordance with Regulation (EU) No. 453/2010 and
OSHA 29 CFR 1910.1200 HCS
NOCOCUT MLV
1.
Identification of the Substance/ Mixture and of the Company/ Undertaking
Product Name: NOCOCUT MLV
Preparation Date: May 21, 2015
Revision Date: November 3, 2015
Recommended Use: Metal Cutting/Grinding Oil
Supplier: NOCO ENERGY CORP.
2440 Sheridan Drive
Tonawanda, NY 14150
Phone: 716-874-6200
EMERGENCY NUMBER: CHEMTREC (800) 424-9300
2.
Hazards Identification
GHS Classification: Aspiration Toxicity – Category 1
H304 – May be fatal if swallowed and enters airways
GHS Labeling:
Symbols:
Signal Word: Danger
Precautionary Statements:
P301 + P310: If swallowed, immediately call a poison center or doctor/physician
P301+P331: If swallowed, do NOT induce vomiting
P405: Store locked up
P501: Dispose of contents/ container to an approved waste disposal plant
Classification according to Regulation (EC) No. 1272/2008 [CLP/GHS] and OSHA 29 CFR 1910.1200
HCS: Aspiration Toxicity – Category 1
Other Hazards Not Classified: No significant hazards
3.
1
Composition/Information on Ingredients
Safety Data Sheet in accordance with Regulation (EU) No. 453/2010 and
OSHA 29 CFR 1910.1200 HCS
NOCOCUT MLV
Chemical Name
Severely Solvent Refined Light
Paraffinic Distillate
4.
CAS Number
64741-77-1
Concentration, Wt. %
Trade secret
First Aid
Inhalation: Remove from further exposure. For those providing assistance, avoid exposure to yourself or
others. Use adequate respiratory protection. If respiratory irritation, dizziness, nausea, or unconsciousness
occurs, seek immediate medical assistance. If breathing has stopped, assist ventilation with a mechanical
device or use mouth-to-mouth resuscitation.
Eyes: Flush thoroughly with water. If irritation occurs, get medical assistance.
Ingestion: Do not induce vomiting. Contact a physician immediately.
Skin:
5.
Wash affected area with soap and water. Remove contaminated clothing.
Launder contaminated clothing before re-use.
Fire-fighting Measures
Suitable extinguishing media: Use water fog, foam, dry chemical or carbon dioxide (CO2) to extinguish
flames.
Specific hazards: Combustible. Vapors are flammable and heavier than air. Vapors may travel across the
ground and reach remote ignition sources causing a flashback fire danger. Hazardous material.
Specific protective equipment and precautions for fire fighters: Combustible. Evacuate area. Prevent
runoff from fire control or dilution from entering streams, sewers, or drinking water supply. Firefighters
should use standard protective equipment and in enclosed spaces, self-contained breathing apparatus
(SCBA). Use water spray to cool fire exposed surfaces and to protect personnel.
Unusual Fire and Explosion Hazards: None
Flammability Properties:
Flash point: 257°F/ 125°C
Method Used: PMCC
6.
Accidental Release Measures
Personal precautions, protective equipment and emergency procedures:
Avoid contact with spilled material. Warn or evacuate occupants in surrounding and downwind areas if
required due to toxicity or flammability of the material. Additional protective measures may be necessary,
depending on the specific circumstances and/or the expert judgment of the emergency responders. For
emergency responders: Respiratory protection: half-face or full-face respirator with filter(s) for organic
vapor and, when applicable, H2S, or Self Contained Breathing Apparatus (SCBA) can be used depending
on the size of spill and potential level of exposure. If the exposure cannot be completely characterized or
an oxygen deficient atmosphere is possible or anticipated, SCBA is recommended. Work gloves that are
resistant to aromatic hydrocarbons are recommended. Chemical goggles are recommended if splashes or
2
Safety Data Sheet in accordance with Regulation (EU) No. 453/2010 and
OSHA 29 CFR 1910.1200 HCS
NOCOCUT MLV
contact with eyes is possible. Small spills: normal antistatic work clothes are usually adequate. Large
spills: full body suit of chemical resistant, antistatic material is recommended.
Environmental Precautions: In the event of a spill or accidental release, notify relevant authorities in
accordance with all applicable regulations. US regulations require reporting releases of this material to the
environment which exceed the applicable reportable quantity or oil spills which could reach any waterway
including intermittent dry creeks.
Methods and materials for containment: Dike far ahead of liquid spill for later recovery and disposal.
Prevent entry into waterways, sewers, basements or confined areas.
7.
Handling and Storage
Precautions for safe handling: Avoid contact with skin. Prevent small spills and leakage to avoid slip
hazard. Material can accumulate static charges which may cause an electrical spark (ignition source). Use
proper bonding and/or ground procedures.
Conditions for safe storage: The container choice, for example storage vessel, may effect static
accumulation and dissipation. Keep container closed. Handle containers with care. Open slowly in order to
control possible pressure release. Store in a cool, well-ventilated area. Storage containers should be
grounded and bonded. Fixed storage containers, transfer containers and associated equipment should be
grounded and bonded to prevent accumulation of static charge
8.
Exposure Controls/Personal Protection
Control parameters:
Exposure Guidelines:
Severely Solvent Refined Light Paraffinic Distillate: OSHA PEL: 5mg/m3 ACGIH TLV: 5 ppm TWA (8
hour)
Appropriate engineering controls: Proper protection and controls is dependent upon the potential
exposure conditions. Adequate ventilation should be provided so that exposure limits are not exceeded.
Use explosion-proof ventilation equipment.
Individual protective measures:
Personal protective equipment selections vary based on potential exposure conditions such as
applications, handling practices, concentration and ventilation. Information on the selection of
protective equipment for use with this material, as provided below, is based upon intended, normal
usage.
Respiratory protection: If engineering controls do not maintain airborne contaminant concentrations at a
level which is adequate to protect worker health, an approved respirator may be appropriate. Respirator
selection, use, and maintenance must be in accordance with regulatory requirements, if applicable. Types of
respirators to be considered for this material include:
Half-face filter respirator
For high airborne concentrations, use an approved supplied-air respirator, operated in positive pressure
mode. Supplied air respirators with an escape bottle may be appropriate when oxygen levels are
3
Safety Data Sheet in accordance with Regulation (EU) No. 453/2010 and
OSHA 29 CFR 1910.1200 HCS
NOCOCUT MLV
inadequate, gas/vapor warning properties are poor, or if air purifying filter capacity/rating may be exceeded.
Eye protection: If contact is likely, safety glasses with shields or chemical goggles are required. Contact
lenses should not be worn if the product could be splashed into the eyes.
Hand protection: Chemical resistant gloves are recommended.
Body protection: Chemical/oil resistant clothing is recommended.
9.
Physical and Chemical Properties
Appearance: Clear amber liquid
Odor: Petroleum odor
Odor Threshold: Not determined
pH : @ 5% in water: N/A
Freezing point: Not determined
Initial boiling point and boiling range: Not determined
Flash Point (PMCC): 257°F/ 125°C
Evaporation Rate (n-butyl acetate = 1): Not determined
Flammability (Solid, Gas): Not determined
Flammable limits (Approximate volume % in air): Not determined
Vapor pressure: Not available
Vapor density (Air = 1): Not available
Relative density: 0.85+/-0.01 @ 15.5oC
Partition coefficient n-octanol/water: Not determined
Autoignition Temperature: Not available
Decomposition Temperature: Not determined
Viscosity: 4.0 – 6.5 cSt @40°C
10. Stability and Reactivity
Chemical stability: Stable at normal conditions
Possibility of hazardous reactions: Not expected and hazardous polymerization will not occur
Conditions to avoid: Excessive Heat.
Incompatible Materials: None known.
Hazardous decomposition products: Material does not decompose at ambient temperatures.
11. Toxicological Information
Inhalation: Inhalation may cause central nervous system effects. May be irritating to the respiratory tract.
Skin: Minimally toxic. Prolonged contact may cause mild irritation
Eyes: Contact may cause mild, short-lasting discomfort to eyes.
Oral: Minimally toxic
Systemic (other target organ) Effects: None known
Teratology (birth defects): None known
4
Safety Data Sheet in accordance with Regulation (EU) No. 453/2010 and
OSHA 29 CFR 1910.1200 HCS
NOCOCUT MLV
Reproductive Effects: None known
Mutagenicity (effects on genetic material): None known
Carcinogenicity: IARC: NO
NTP: No
OSHA: No
12. Ecological Information
Persistence and degradability: Not expected to be readily biodegradable
13. Disposal Considerations
Disposal methods: Dispose of in accordance with federal, state and local regulations
Precaution for disposal: All recovered material should be packaged, labeled, transported
and disposed or reclaimed in conformance with Good Engineering Practices. Comply with all applicable
governmental regulations. Avoid land filling of liquids. Reclaim where possible.
14. Transport Information
USA DOT (Land): Not regulated.
IMDG (Sea): Not regulated as a hazardous material or dangerous goods for transportation.
IATA (Air): Not regulated as a hazardous material or dangerous goods for transportation.
15. Regulatory Information
US TSCA: In compliance with the inventory
Canada DSL: In compliance with the inventory
OSHA HAZARD COMMUNICATION STANDARD: When used for its intended purpose, this
material is classified as hazardous in accordance with OSHA 29CFR 1910.1200.
Complies with the following national/regional chemical inventory requirements: ENCS, IECSC,
DSL, AICS, TSCA, KECI, PICCS
Cal. Prop. 65 This product does not intentionally contain any chemicals known by the State of California to
cause cancer and/or birth defects. Moreover, we do not routinely analyze its products for impurities which
may be such chemicals.
EPCRA: This material contains no extremely hazardous substances.
CERCLA: This material is not subject to any special reporting under the requirements of the
Comprehensive Environmental Response, Compensation and Liability Act (CERCLA). CERCLA
petroleum exclusion applies for this product. Contact local authorities to determine if other reporting
requirements apply.
CWA / OPA: This product is classified as an oil under Section 311 of the Clean Water Act (40 CFR 110)
and the Oil Pollution Act of 1990. Discharge or spills which produce a visible sheen on either surface
water, or in waterways/sewers which lead to surface water, must be reported to the National Response
Center at 800-424-8802.
5
Safety Data Sheet in accordance with Regulation (EU) No. 453/2010 and
OSHA 29 CFR 1910.1200 HCS
NOCOCUT MLV
SARA (311/312) REPORTABLE HAZARD CATEGORIES: None
SARA (313) TOXIC RELEASE INVENTORY: This material contains no chemicals subject to the
supplier notification requirements of the SARA 313 Toxic Release Program.
VOC Content (SCAQMD ASTM 1868-10): This product exceeds South Coast Air Quality Management
District (SCAQMD) limits for VOC per ASTM E-1868-10 and may not be offered for sale or use within
that district.
16. Other Information
Special Precautions to be Taken in Handling and Storage:
Normal precautions common to good manufacturing practices should be followed in handling and storing.
Store away from food. Wash hands before eating, drinking or smoking. Use as directed.
Disclaimer: This document has been prepared in good faith and from information provided to us by our
suppliers and other sources considered to be reliable. No warranty, express or implied is given. The buyer is
responsible to evaluate all available information when using this product for any particular use. The buyer is
also responsible for complying with all Federal, State, Provincial, and Local Laws and regulations when
using this product.
6