TFTNMOAT MSDS - Toxguard Fluid Technologies

advertisement
MSDS
Material Safety Data Sheet
Product Organic Acid Heavy Duty Fully Formulated Coolant
Revision Date 12/11/11
Manufacturer
Toxguard Fluid Technologies, Inc.
11942 Western Ave
Stanton, CA 90680
Contact Phone Number 714-698-3400
714-698-3404 FAX
Product Name: Toxguard Fully Formulated Nitrite Molybdate Organic Acid Technology
BTNMOAT
I.Identification
II.Synonyms: Aqueous Solution of Nitrites and Sodium Tolytriazole
III.Formula: See Section II
IV.Emergency Telephone:
V.Information Telephone:
VI.Chemical Family:
VII.DOT Hazard Class:
VIII.DOT Shipping Name:
800-262-8200 Chemtrec
714-6983400....714-357-4198
Alkali metal salts, aqueous solution
Corrosive Material
Corrosive Liquid, N.O.S., Basic, Inorganic, UN3266, 8, PGII
i. (Contains: Potassium Hydroxide)
IX.Hazardous Ingredients
a. Component Names
b. Product Non-Hazardous
c. CAS#:
X.Material
a. Potassium Hydroxide
b. Sodium Nitrite
% of Product
%
<5
<20
Exposure Limits
OSHA TWA
ACGIH
PPM MG/M3 PPM MG/M3
TLV (Units)
2 mg/m3
------------
CAS#
1310-58-3
7632-00-0
MSDS
Material Safety Data Sheet
Product Organic Acid Heavy Duty Fully Formulated Coolant
Revision Date 12/11/11
XI.Hazards Identification
a. Toxicity: T.L.V. =
2 mg/m3 (potassium hydroxide)
b. Ingredients Listed as Carcinogenic in NTP, IARC, or OSHA (specify): None
c. Emergency Overview: Harmful or fatal if swallowed or absorbed through skin. Harmful to eyes upon
contact.
d. Potential Health Effects:
a. Carcinogenicity: Product not considered a carcinogen by OSHA, NTP or IARC.
b. Medical conditions that may be aggravated by exposure: Pre-existing eye or
skin conditions may be aggravated by overexposure to this product.
c. Target Organs: None known.
d. Primary Entry Routes: Eye and skin absorption.
e. Acute Effects Of Overexposure
1. Eye Contact:
Irritating. Prolonged contact may produce severe damage
to delicate eye tissue.
2. Skin Contact:
Mildly irritating. Prolonged or repeated contact with skin
can cause irritation.
3. Inhalation:
Product non-volatile, inhalation hazard unlikely. Irritating
to respiratory tract.
4. Ingestion:
Poisonous. Product may be harmful or fatal if swallowed.
5. Principal Routes of Absorption: Skin and eye contact.
6. Chronic Health Effects:
Repeated skin contact can cause
persistent irritation and dermatitis.
ii. Chronic Health Effects: 1 Health
0 Flammability 0 Reactivity
iii. 0=Insignificant
1=Slight
2=Moderate
3=High
4=Severe
XII.Emergency And First Aid Procedures
1. Eyes: Flush at once with plenty of cool water for 15 minutes. Contact a
physician.
2. Skin: Flush affected area with plenty of soap and water. If irritation develops,
consult a physician.
3. Inhalation: Remove victim to fresh air. If not breathing, give artificial
MSDS
Material Safety Data Sheet
Product Organic Acid Heavy Duty Fully Formulated Coolant
Revision Date 12/11/11
respiration. Seek medical attention. Inhalation hazard unlikely due to low
volatility of product. If symptoms persist, consult a physician.
4. Ingestion: Seek medical attention immediately. Give two glasses of water and
induce vomiting. Give CONCIOUS victim glass of water. Never give water to
unconscious victim.
XIII.Fire Fighting Measures
i.
ii.
iii.
iv.
v.
vi.
Closed Cup Flash Pt.:
Open Cup Flash Point:
Fire Point:
Auto Ignition:
Lower Explosion Limit:
Upper Explosion Limit:
NG
NG
NG
NG
NG
NG
Extinguishing Media: Carbon Dioxide, Dry Chemical, Foam.
Unusual Fire and Explosion Hazards: none known.
XIV.Fire Fighting Equipment: Self contained breathing apparatus with full face piece operated in pressure
demand or positive pressure mode.
a. Note: Product will not support combustion.
XV.Physical Data
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
Boiling Point, 760 mm Hg:
Freeze Point, < 32 F
Specific Gravity (H2O=1):
Vapor Density (Air=1):
Vapor Presure:
% Volatile by Volume:
pH:
Solubility in Water:
Evaporation Rate:
Molecular Weight:
Appearance and Odor:
BT
212°F
1.0
NG
NG
65
9.0
Complete
NG
NG
Orange Pink liquid; slight odor
215°F
MSDS
Material Safety Data Sheet
Product Organic Acid Heavy Duty Fully Formulated Coolant
Revision Date 12/11/11
XVI.Reactivity Data
a.
b.
c.
d.
e.
f.
Stability: Stable: XX Unstable:
Conditions to Avoid: N/A
Polymerization: hazardous polymerization cannot occur.
Incompatibility (materials to avoid): Strong acids, strong oxidizers, extreme heat.
Hazardous Polymerization: May Occur:
Will Not Occur: XX
Conditions to Avoid: Excessive heat and open flame
XVII. Ecological Information
a. no data
XVIII. Disposal Considerations
a. As a waste, this product can be treated to meet local sanitary district standards.
b. Dispose of in accordance with all applicable state federal and local regulations.
XIX. Spill Or Leak Procedures
a. Spill/Leak Procedure: Notify safety personnel, evacuate all necessary personnel and provide
adequate ventilation. If feasible without risk, clean-up personnel should stop leak. All clean-up
personnel should wear protective equipment.
b. Small Spill: Clean up with inert absorbent and place in recovery drums for disposal.
c. Large Spill: Dike to prevent further migration of material. Do not release into waterways or
sewers. Follow applicable OSHA regulations 20CFR1910.120
d. Waste Disposal Method: In accordance with federal, state, and local guidelines.
XX. Transportation Information
a. Shipping regulations
i. UN/NA Number: NG
ii. DOT Hazardous Class: none
iii. Shipping Label: none
iv. Name:
XXI. Special Protection Information
a. Ventilation Requirements: N/A
b. Recommended Personal Protective Equipment
i. Respiratory:
ii. Eyes:
iii. Gloves:
N/A
Chemical splash goggles
Impervious to mildly alkaline solutions.
MSDS
Material Safety Data Sheet
Product Organic Acid Heavy Duty Fully Formulated Coolant
Revision Date 12/11/11
iv. Other Clothing and Equipment: N/A
XXII.Special Precautions
a. Precautions to be Taken in Handling and Storing: Keep container closed. Keep out of reach
of children. Store in a cool, dry place.
b. Personal Protective Equipment:
i. Eye Protection: chemical splash goggles with indirect or no ventilation.
ii. Skin Protection: chemical resistant gloves
iii. Respiratory Protection: none required under normal use.
c. Engineering Controls: Eye wash station and safety shower.
d. Ventilation: Material non-volatile. General ventilation should be sufficient.
e. Other Precautions: For industrial use only.
f. Comments: Never eat, drink or smoke in work areas.
XXIII. Regulatory Information:
a. US Federal Regulations
i. OSHA: considered hazardous as defined by 29CFR1910.1200.
ii. EPA SARA TitleIII
1. Section 311-312 (40CFR370): if stored in excess of the threshold quantities,
this product should be reported as a(n) –Immediate (acute) health hazard.
2. Section 313 (40CFR372): This product does not contain ingredients, which
are subject to the reporting requirements SARA 313.
b. State Regulations
i. California Proposition 65: This product does not contain ingredients that are losited
on current Proposition 65 list.
ii. New Jersey Right to Know: This product contains the following ingredients, which
are non-hazardous, but are among the top five ingredients in this product:
iii. Ingredient
Cas#
Water
7732-18-5
2 Ethyl Hexanoic Acid Sodium Salt
19776-89-3
Sodium Nitrite
7632-00-0
Sodium Tolytriazole
6466-57-2
MSDS
Material Safety Data Sheet
Product Organic Acid Heavy Duty Fully Formulated Coolant
Revision Date 12/11/11
All information, recommendations, and suggestions appearing herein concerning this compound are based upon
data obtained from the raw material manufacturers and/or recognized technical sources; however, Blend Tech, Inc.
makes no warranty, representation, or guarantee as to the accuracy, sufficiency or completeness of the material set
forth herein. It is the user's responsibility to determine the safety, toxicity and suitability of his own use, handling
and disposal of the product. Since actual use by others is beyond our control, no warranty, express or implied is
made by Blend Tech, Inc. as to the effects of such use, the results to be obtained or the safety and toxicity of the
product. The data in this MSDS relate only to the specific product designated herein and do not relate to use in
combination with any other material or in any process.
Download