Name ______________________________________ AM PM 29103-09 Study Guide Use the PowerPoint to fill in the blanks. 1. In plasma arc cutting, plasma is created by _____. 2. In most cases, plasma arc cutting is _____ than other cutting methods. 3. In the transferred arc process, the workpiece is _____. 4. The simplest plasma arc cutting units use filtered _____ for plasma and cooling gas. 5. Industrial plasma cutting units can cut carbon steel up to _____ thick. 6. The most common plasma arc cutting torch uses _____. 7. The typical plasma arc cutting torch contains a _____. 8. The most common parts that are changed in a torch are the _____. 9. When performing plasma arc cutting near a battery, the operator should remove the battery to prevent _____. 10. If cylinders are to be removed from a plasma arc cutting unit before it is stored, be sure to remove the regulators and _____. Name ______________________________________ AM PM 11. Most heavy-duty plasma arc cutting systems require one gas cylinder containing the cutting gas and another containing _____. 12. Cutting a 2" aluminum plate will require a(n) _____. 13. To pierce very thin metal using plasma arc cutting, hold the torch at a _____- degree work angle. 14. When compressed air is used with a PAC unit, the correct air flow rate and pressure are maintained by _____. 15. Sputtering or hissing of the torch is often caused by _____.