CHEMFAX PRODUCTS Ltd.
1106-46 Avenue S.E. Calgary, Alberta T2G 2A6
(403)287-2055 Fax(403)287-6545
In Case of Emergency Only:
Phone CANUTEC: (613)996-6666
‘SOLVENT’
WHMIS CODES:
B3 D2B
SECTION 1: MATERIAL IDENTIFICATION
Product Identifier:
Solvent
Chemical Name:
Solvent
Chemical Family:
Petroleum Distillates
Chemical Formula:
Not applicable
Molecular Weight:
Not applicable
Trade Name-Synonym:
Solvent
Material Use:
Industrial Solvent
Flammability:
2
Reactivity:
0
Health:
1
Personal Protection:
2
SECTION 2: HAZARDOUS INGREDIENTS OF MATERIAL
Hazardous Ingredients:
Solvent
Approximate Concentrations %: 100 %
Exposure Limits:
100 ppm Stoddards Solvent
25ppm Trimethylbenzene
LD:50 LC:50/Species/Route:
LD:50 5g/kg(oral rat), LC:50 5g/m3 (rat)
CAS#:
8052-41-3
SECTION 3: PHYSICAL DATA FOR MATERIAL
Physical State:
Liquid
Odour and Appearance:
Light coloured liquid with aromatic odour.
Odour Threshold (PPM):
1 - 30 ppm
Specific Gravity:
079 @ 15.5 oC
Vapour Pressure (mm Hg):
<0.133 KPA @ 20oC
Vapour Density (air = 1):
4.8
Boiling Point (°oC):
156 to 197°oC
Solubility in Water:
Insoluble
% Volatile:
100 %
pH:
Not available
Density:
Not available
Coefficient of Water/Oil:
Not available
Freezing Point:
Not available
SECTION 4: FIRE AND EXPLOSION HAZARD
Flammability:
Flammable
Flash Point (°oC):
43 oC TCC
Upper Flammable Limit (% by volume): 13.3 %
Lower Flammable Limit (% by volume): 1 %
Autoignition Temperature (°oC):
229 oC
Hazardous Combustion Products:
Toxic gases will form upon combustion
Explosive Power:
Sensitivity to Static Discharge:
Means of Extinction:
Special Procedures:
Will form explosive mixtures with air
Yes
Foam, water fog, dry chemicals
Fire fighters should wear self contained breathing
apparatus and full protective clothing. Use water
spray to disperse vapours and to cool containers and
nearby structures exposed to fire. Vapours may settle
in low areas, or travel along the ground to ignition
sources. Storage and pumping equipment should be
grounded.
SECTION 5: REACTIVITY
Chemical Stability:
Under Fire Conditions:
Incompatibility to Products:
Reactivity, and under what Conditions:
Hazardous Decomposition Products:
Hazardous Polymerization:
Conditions to Avoid:
Materials to Avoid:
SECTION 6: TOXICOLOGICAL AND HEALTH
Route of Entry Skin Contact:
Route of Entry Skin Absorption:
Route of Entry Eye Contact:
Route of Entry Inhalation Acute:
Route of Entry Inhalation Chronic:
Route of Entry Ingestion:
Reproductive Effects:
Mutagenicity:
Teratogenicity:
Carcinogenicity:
Synergenistic Materials:
Sensitization to Product:
Exposure Limits:
Irritancy of Product:
LD:50 LC:50/Species/Route:
Effects of Chronic Exposure:
Effects of Acute Exposure:
SECTION 7: PREVENTATIVE MEASURES
Stable
Flammable, will produce irritant fumes, smoke,
CO and CO2
Strong oxidizing agents
Strong oxidizing agents
No data
Will not occur
High temperatures, sparks, open flames and
sources of ignition.
Strong oxidizing agents
DATA
Yes
Yes
Yes
Yes
Yes
Yes
No data
No data
No data
No data
No data
No data
100 ppm Stoddards Solvent
25ppm Trimethylbenzene
Irritant to eyes, nose, mouth, throat, skin and
respiratory tract.
LD:50 5g/kg(oral rat), LC:50 5g/m3 (rat)
May cause abdominal pain, CNS depression, coma,
possible death due to respiratory failure.
Intentional misuse of solvent e.g. glue sniffing over
prolonged periods of time have caused neurological
effects as well as liver and kidney injury. May cause
dermatitis, burning of the mouth and throat.
May cause severe irritation of eyes, nose, throat,
respiratory tract, corneal damage, headache,
dizziness, drowsiness, nausea, vomiting, abdominal
pain, lack of coordination and defatting of the
skin.
Personal Protective Equipment:
Gloves (Specify):
Respirator (Specify):
Eyes (Specify):
Footwear (Specify):
Clothing (Specify):
Other (Specify):
Engineering Controls:
Leak and Spill Procedure:
Waste Disposal:
Handling Procedures and Equipment:
Storage Requirements:
Special Shipping Information:
If engineering controls are effective no special
requirements should be needed. Wear full protective
equipment with self contained breathing apparatus if
large spills occur or exposure limits will be
exceeded
Rubber, neoprene.
SCBA or SAR with organic vapour cartridge if exposure
limits will be exceeded.
Safety goggles.
Rubber boots.
Rubber apron, rubber pants and jacket if conditions
require such - ie spill or accidental release.
Eye wash fountain, safety shower.
Mechanical ventilation / exhaust systems should be in
place. Use explosion proof equipment.
Restrict access to the area until completion of clean
up. Eliminate all ignition sources. Ventilate area.
Contain spill with earth or sand. Collect material
into a suitable container for disposal.
Dispose of according to Federal, Local and Provincial
Regulations.
Use material with plenty of ventilation. Keep
container closed at all times. Do not smoke in area.
Empty container may contain flammable residue.
Store in cool, dry, well ventilated area. Keep away
from fire, sparks, open flames and other sources of
ignition.
Naptha Solvent Class 3.3 U.N. 1256 P.G. III
SECTION 8: FIRST AID MEASURES
Skin:
Eyes:
Ingestion:
Inhalation:
General Advice:
Flush with plenty of water for at least 15 minutes. Remove and discard
contaminated clothing immediately. Flush affected area with plenty of
water and call a physician at once.
Flush with plenty of water for at least 15 minutes. Keep eye lids open
when flushing with water and get medical attention at once.
Never give anything by mouth to a convulsing or unconscious person. Do
not induce vomiting. Drink plenty of water. If vomiting occurs, have
person lean forward to reduce aspiration. Get medical attention
immediately. General Supportive Measures: comfort, warmth, rest.
Move victim to fresh air. If breathing stops, give CPR. Avoid mouth to
mouth contact. Give oxygen by trained personnel only.
Keep out of reach of children.
SECTION 9: PREPARATION DATE OF M.S.D.S.
Prepared by: Technical Service Dept., Chemfax Products Ltd.
(403)287-2055 August 1, 2002
Notice to reader
To the best of our knowledge, the information contained herein is accurate. However,
neither the above named supplier nor any of it’s subsidiaries assumes any liability
whatsoever for the accuracy or completeness of the information contained herein. Final
determination of suitability of any material is the sole responsibility of the user. All
materials may present unknown hazards and should be used with caution. Although certain
hazards are described herein, we cannot guarantee that these are the only hazards that
exist.
Chemfax Products Ltd. expressly disclaims all expressed or implied warranties of
merchantability and fitness for a particular purpose with respect to the product
provided.