STEARMAN PROJECTS
LIST OF PARTS OF WHAT’S INCLUDED
July 2014
1. One excellent frame that has been re-welded, bead-blasted and powder coated.
2. 1 set Bendix landing gear complete with long or short axles
3. Complete set of Landing gear-leg formers.
4. BT or Stearman wheels and brake assemblies
5. Two Stearman hydraulic master cylinders
6. Two aluminum Stearman seats. (one needs a little work)
7. Four seat posts with sockets
8. Two “rear” pedal hangars, with two pedal assemblies
9. Four pedal bell-cranks
10. Four pedal-to-bell-crank rods
11. Set of Pedal interconnect rod-ends.
12. Set Pedal adjuster interconnect channels
13. One Very Good vertical rudder
14. One Very Good vertical stabilizer
15. One very good horizontal tail
16. Two good elevators
17. One tail wheel casting
18. One tail wheel trunion
19. One tail wheel fork with axle, bell-crank and spring
20. One tail wheel strut
21. One tail-wheel hub
22. One New tail wheel canvas boot
23. One New tail wheel strut boot
24. One Complete set of Tail surface wires with clevis’s and attach fittings
25. One Continental engine mount, blasted and powder coated
26. One Continental engine “fire ring”
27. One set of Continental exhaust pipes, and set of SS flashings
28. Two throttle quad assemblies
29. One Carb Heat lever assembly
30. One Rear cockpit Trim Control bracket assembly with pulley
31. Part of Front cockpit Trim Control bracket (repairable ), with pulley
32. One Complete Trim transmission with pulleys and brackets
33. Fuel and Magneto Levers
34. One pair of full length and ORIGINAL, CORREGATED FOOT TRAYS,
35. Serviceable Center Section assembly (probably flyable)
36. One good fuel tank and accessories.
37. One set center-section struts and flying wires with clevis’s,
38. Two good ailerons
39. 100% Complete set of hardware for upper wings.
40. 99% Hardware for two lower wings, (missing one front strut attach bracket)
41. Complete set of N struts with Pitot tube
42. Complete set of wing flying wires with Clevis’s
43. One long elevator push-pull tube
44. One short elevator push-pull tube
45. One elevator push-pull idler lever
46. One set of two rudder cable idler levers and springs
47. Control-stick torque tube (full length) with bellcrank
48. Two control-stick sockets
49. One set of mounting fittings for control stick torque tube (with bearings)
50. Several repairable control panel formers
51. Two instrument panel plates
52. Some instruments
53. Complete set of windshield GLASS. (no frames)
54. One NEW, NOS, baggage compartment bulkhead (behind rear pilot)
55. One baggage door, needing some lovin’
56. One New baggage compartment bag
57. One fuel strainer with mounting bracket
58. One Fuel Valve
59. One oil “Y” drain
60. NEW stainless steel firewall with NEW flanges
61. One set of FWF Continental engine bell-cranks and channel brackets
62. Sheet metal fuselage cockpit side and top cowling
63. One Lower engine “chin” cowl for Continental.
64. NEW NOS trapezoidal fuselage belly-cowl panel between gear legs
65. Engine Carb air-intake casting (Lycoming or Continental)
66. Carb Air snorkel intake; top, center and lower assembly (missing the filter element)
67. Engine starter-crank and primer bracket
(Lycoming or Continental)
68. One Oil Tank with mounting hardware
69. One oil feed and oil-temp goose-neck for Continental
70. Engine top “walk-way” cowl
71. Both Engine top accessory cowls
72. Both Engine LH and RH engine side cowls, Lycoming, or Continental.
73. Fuselage front/side cowl doors (LH & RH)
74. TWO NEW, NOS, lower, front/side, fuselage to gear cowls.
75. One upper engine accessory cowl former, including Magneto switch
76. Some bird cage parts
77. Fuselage rear turtle deck (needs front bulkhead)
78. Full set of “C” clamps
79. Full set of bird cage clamps
80. In addition, many other miscellaneous sheet metal pieces, brackets, cables, fittings
and other hard-to-find small stuff…
81. PLUS……., Registered Ownership papers with valid N number
Missing Parts:
1. Two windshield frames
2. Two elevator trim handles
3. Tail-wheel cone fairing
4. Most Birdcages
5. Two pedals pads
6. And some other miscellaneous small stuff
Also “Available”:
1. TWO Lycoming 220hp engines, can be combined into one good one.
2. Zero time Overhauled McCauley prop for Stearman
3. Another second, re-welded and painted fuselage frame, and many more Stearman parts
4. Another landing gear assembly with wheels and brakes
5. Another complete set of flying wires and clevis’s
6. Another complete set of tail wires and clevis’
7. Another horizontal tail
8. Another rudder
9. More elevators
10. More ailerons
11. Two more throttle quadrants
12. One more Carb heat lever
13. Some more pedal components
14. Another complete trim tab transmission and pulleys
15. Some more wing hardware and components
16. Another complete center-section with hardware
17. Another good fuel tank
18. Some extra N struts
19. Another Continental engine mount
20. Another Continental chin cowl
21. More engine accessory cowls and fuselage side barn doors
22. Another set of gear leg formers
23. Another full-length control-stick tube with mounting brackets
24. More push-pull tubes
25. Many of the other smaller parts
26. Lots more birdcage clamps and C clamps
Fritz Mehrer
Oceanside, CA.