INTERNATIONAL JOURNAL OF ELECTRONICS AND COMPUTER TECHNOLOGY First Author1, Second Author2, Third Author3 1 First author affiliation & address 2 3 Second author affiliation & address Third author affiliation & address Abstract— This document presents the formatting guidelines for author(s) for preparing the papers to publish in the International Journal of Electronics and Computer Technology. The authors must follow the guidelines given in the document. Title must be Times New Roman, Bold, centre aligned with font size of 20. Author name must be in 12 pt regular font. Author affiliation and email address must be in 10 pt Italic and regular respectively. Keywords—Keywords are author(s) chosen list of words for easy location of the paper using various search engines. There must be at least 5 keywords, arranged alphabetically separated comma. B. Text Font of Entire Document I. INTRODUCTION This is template document. Author(s) are informed to adhere the guidelines mentioned in the document. In order to easily prepare our manuscript, the author(s) may simply paste the desired content in this template file. This template file acts as the blue print for the manuscript to be prepared for submission in International Journal of Electronics and Computer technology. The entire content in paragraphs should be in Times New Roman with font size of 10. All the paragraphs must be indented. Recommended font sizes are as given in Table I. C. Manuscript Title and Author Details TABLE I FONT SIZES FOR PAPERS Font Size 9 II. PAGE LAYOUT The submitted paper must be in two column format with spacing of 0.5 inch in between the columns; as referred in this template document. 10 10 Page Layout The margins must be set as follows: Top = 1.7cm Bottom = 1.7cm Left = 1.7cm Right = 1.7cm III. IV. PAGE STYLE All paragraphs must be indented and justified. A. Manuscript Title and Author Details 12 I. Appearance (in Time New Roman or Times) Regular table caption (in Small Caps), figure caption, reference item author email address, cell in a table level-1 heading (in Small Caps), paragraph Bold Italic reference item (partial) abstract body abstract heading (also in Bold) level-2 heading, level-3 heading, author affiliation Author name The Manuscript Title and all the author details must be in single-column format and must be center aligned. Email address is compulsory for the corresponding author and should preferably be included for all author(s). D. Section Headings Unless must required, not more than 3 levels of headings should be used. All headings must be in 10pt font. Every word in a heading must be capitalized as given in all above headings. Page 1 of 2 i) Level-1 Heading: A level-1 heading must be in Small Caps, centered and numbered using uppercase Roman numerals. For example, see heading “I. INTRODUCTION” of this document. The author(s) should not include the hyperlinks in any part of the manuscripts. If required, the link address must be typed in regular font. ii) Level-2 Heading: A level-2 heading must be in Italic, left-justified and numbered using an uppercase alphabetic letter. For example, see heading “B. Text Font of Entire Document”. References iii) Level-3 Heading: A level-3 heading must be indented, in Italic and numbered with an Arabic numeral followed by a right parenthesis. The level-3 heading must end with a colon. The body of the level-3 section immediately follows the level-3 heading in the same paragraph. For example, the body of “level-2 Heading” begins immediately after the heading. E. Figures and Tables Figures and tables must be centered in the column. Large figures and tables may span across both columns. Any table or figure that takes up more than 1 column width must be positioned either at the top or at the bottom of the page. F. Table Caption Tables must be numbered using uppercase Roman numerals and must be centred and in 9 point regular font with Small Caps. Every word in a table caption must be capitalized except for short minor words. Captions with table numbers must be placed before their associated tables, as shown in Table I. Captions of a single line must be centered whereas multi-line captions must be justified. Figures must be numbered using arabic numerals. Figure captions must be in 9 pt Regular font. Captions of a single line must be centered whereas multi-line captions must be justified. Captions with figure numbers must be placed after their associated figures The heading of the references section must not be numbered. All reference items must be in 9 pt font. Author(s) are advised to use regular and italic styles to distinguish different fields as shown in the references section. The references must be numbered consecutively in square brackets. (e.g. [4]). Few examples of references are as given below: [1] Wang, Y., & Moulin, P. 2003. Steganalysis of block-DCT image steganography. In IEEE workshop on Statistical Signal Process (pp. 339-342). [2] Matsuoka, H. 2006. Spread spectrum audio steganography using sub-band phase shifting. In Intelligent Information Hiding and Multimedia Signal Processing, 2006. IIHMSP'06. International Conference on (pp. 3-6). IEEE. [3] Logeshwaran, R., and Paul, I. J. L. 2010. Performance study on the suitability of Reed Solomon Codes in WiMAX. In Wireless Communication and Sensor Computing, 2010. ICWCSC 2010. International Conference on (pp. 1-4). IEEE. [4] Orphanoudakis, T., Leligou, H. C., Kosmatos, E. and Angelopoulos, J. D. 2009. Performance evaluation of GPON vs EPON for multi‐service access.International Journal of Communication Systems, 22(2), 187-202. [5] Huang, Z., Zhu, Y., Chen, X., & Wang, A.(2005). Intrinsic Fabry-Perot fiber sensor for temperature and strain measurements. IEEE photonics technology letters, 17(11), 24032405. G. Page Numbers, Headers and Footers The page numbers must be at bottom (in footer) and centred. The header must include the journal’s identification as shown in this template document. H. Links and Bookmarks Page 2 of 2