Item
DL 3155E14
Spec's
Spec's with Sw
TRANSISTOR AMPLIFIER CIRCUITS - didactic equipment - circuit blocks:
attenuator,
common base / emitter, common collector, bias stabilization, RC
Coupling / Transformer Coupling, direct coupling - theoretical topics:
Idea of linear amplification of current, voltage and power, common base
configuration: circuit and behaviour, common emitter configuration:
circuit and behaviour, common collector configuration (emitter
follower): circuit and behaviour, circuits for the control of alternate
current motors, thermal and bias stabilization of a linear amplifier, static
and dynamic load lines, multi-stage amplifiers, RC coupled amplifiers,
transformer coupled amplifiers, direct-coupled amplifiers. Fault
simulation. It must be possible to perform the following experiences:
The common base amplifier, The common emitter amplifier, The
common collector amplifier, Bias stabilization, RC coupled amplifier,
Transformer Coupled amplifier, Direct Coupled amplifier. The faults
must be inserted by microswitches mounted on the board; the module
must be provided with a EISA BUS 31+18 INTERFACE, connections and
test points by 2mm terminals.
Dimensions of the module: 297x260mm.
The module must be supplied with a theoretical and practical manual.
TRANSISTOR AMPLIFIER CIRCUITS - didactic equipment - circuit blocks:
attenuator,
common base / emitter, common collector, bias stabilization, RC Coupling
/ Transformer Coupling, direct coupling - theoretical topics: Idea of linear
amplification of current, voltage and power, common base configuration:
circuit and behaviour, common emitter configuration: circuit and
behaviour, common collector configuration (emitter follower): circuit and
behaviour, circuits for the control of alternate current motors, thermal
and bias stabilization of a linear amplifier, static and dynamic load lines,
multi-stage amplifiers, RC coupled amplifiers, transformer coupled
amplifiers, direct-coupled amplifiers. Fault simulation. It must be possible
to perform the following experiences: The common base amplifier, The
common emitter amplifier, The common collector amplifier, Bias
stabilization, RC coupled amplifier, Transformer Coupled amplifier, Direct
Coupled amplifier. The faults must be inserted by software and by
microswitches mounted on the board. The module must be provided with
a EISA BUS 31+18 INTERFACE for connection to power supply and PC,
with a software able to allow the study of theoretical topics through PC
with hyper textual navigation according to the HTML standard.
Connections and test points by 2mm terminals.
Dimensions of the module: 297x260mm.
The module must be supplied with a theoretical and practical manual.