Material Safety Data Sheet
Infosafe No™.
SEPC9
Product Name:
TOTAL CARE
Issue Date: July 2012
CS:
ISSUED by SEPTONE 1.6.13
Classified as hazardous
1. IDENTIFICATION OF THE MATERIAL AND SUPPLIER
TOTAL CARE
HDTC5, HDTC20
Septone Products Pty Ltd (ABN 50 009 745 537)
44 Aquarium Avenue HEMMANT
QLD 4174
Emergency Tel. Business hours only: 1800 000 945 or New Zealand
Poisons Information Centre 0800 764 766
Telephone/Fax Tel: (07) 3390 5044
Fax: (07) 3390 5041
Number
general@septone.com.au (For NZ customers other
Email
than in emergencies. Your supplier can be
contacted)
Recommended Acid based toilet bowl cleaner with disinfectant.
Use
Other Names
Name
Mancode
TOILET BOWL AND URINAL JBBT5, JBBT20
CLEANER
The information herein is, to the best of our
Other
knowledge, correct and complete. It describes the
Information
safety requirements for this product and should
not be construed as guaranteeing specific
properties. Since methods and conditions of
application are beyond our control, Septone does
not accept liability for any damages resulting
from the use of, or reliance on, this
information, in inappropriate contexts.
Product Name
Product Code
Company Name
Address
2. HAZARDS IDENTIFICATION
Hazard
Classification
Classified as hazardous
HAZARDOUS SUBSTANCE.
DANGEROUS GOODS.
Hazard classification according to the criteria
of NOHSC.
Dangerous goods classification according to the
Australia Dangerous Goods Code.
Risk Phrase(s) Classified as hazardous
R20 Harmful by inhalation.
R35 Causes severe burns.
R36/38 Irritating to eyes and skin.
Safety Phrase(s) S1/2 Keep locked up and out of reach of children.
S26 In case of contact with eyes, rinse
immediately with plenty of water and seek medical
advice.
S36/37/39 Wear suitable protective clothing,
gloves and eye/face protection.
S45 In case of accident or if you feel unwell
seek medical advice immediately
S9 Keep container in a well ventilated place.
3. COMPOSITION/INFORMATION ON INGREDIENTS
Liquid
Chemical
Characterization
Ingredients
Name
Water
Hydrochloric Acid
(Hydrogen Chloride)
Phosphoric Acid
Ingredients
determined not to be
hazardous
CAS
Proportion Hazard R Phrase
7732-185
7647-010
7664-382
-
60-100 %
0-10 %
T, C
R23, R35
0-10 %
C
R34
0-10 %
4. FIRST AID MEASURES
First Aid
Measures
Inhalation
Ingestion
For advice, contact a Poisons Information Centre
(e.g. phone Australia 131 126; New Zealand 0800
764 766) or a doctor.
Rescuers should wear respiratory protection.
Remove the victim from the source of exposure. If
the victim is not breathing, apply artificial
resuscitation. Irrigate the mouth and nasal
passages immediately with water. For all but the
most minor symptoms, seek medical attention.
Do NOT induce vomiting. Give water to drink. Seek
medical attention.
Remove contaminated clothing and launder before
re-use. Wash affected skin with soap and water.
If swelling, blistering, redness or irritation
occurs, seek medical attention.
If in eyes, hold eyelids apart and flush the eye
Eye
continuously with running water. Continue
flushing until advised to stop by a Poisons
Information Centre (e.g. phone Australia 131 126;
New Zealand 0800 764 766) or a doctor, or for at
least 15 minutes.
A safety shower and an eye irrigation facility
First Aid
should be provided. This Material Safety Data
Facilities
Sheet should be provided to the attending medical
doctor.
Advice to Doctor Treat symptomatically.
Skin
5. FIRE FIGHTING MEASURES
Suitable
Extinguishing
Media
Special
Protective
Equipment for
fire
fighters
Specific Hazards
Hazchem Code
Other
Information
Use the extinguisher appropriate to the principal
fire hazard or to the source of the fire.
Fire-fighters should wear full protective
clothing and self contained breathing apparatus
(SCBA).
This product may liberate Hydrogen gas on contact
with metals, thus creating a fire and explosion
hazard. Potential sources of ignition should be
excluded from the immediate area.
2X
This product is not flammable under the
conditions of use and does not support
combustion. However, this product may liberate
Hydrogen gas on contact with metals, thus
creating a fire and explosion hazard.
6. ACCIDENTAL RELEASE MEASURES
Spills & Disposal Personnel involved in cleaning up any spills are
to wear PVC gloves, chemical goggles and/or a
face shield and enclosed footwear. If vapours or
spray mists are likely to be encountered, an acid
resistant respirator to AS 1716 should also be
worn. Move people upwind of the spillage area and
cordon it off. Isolate the source of the spillage
or leak. Contain the spillage using a suitable
non-flammable absorbent material such as sand or
diatomaceous earth, then transfer to sealed
plastic containers for disposal. Dispose of
product in a chemical dump according to local
authority statutory requirements. For residual
amounts, wash the product to the effluent with a
large excess of water.
7. HANDLING AND STORAGE
Precautions for Use in a well ventilated area. Ensure the
Safe Handling appropriate personal protective equipment is used
when handling this material. Do not mix this
product with other chemicals. Use safe workplace
practices and avoid contaminating waterways.
Ensure a high level of personal hygiene is
maintained when using this product. That is;
always wash hands before eating, drinking,
smoking or using toilet facilities.
Conditions for Store in a clean, dry, cool, well ventilated area
away from foodstuffs. Keep containers well sealed
Safe
when not in use.
Storage
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
National
Exposure
Standards
Engineering
Controls
Personal
Protective
Equipment
Name
mg/m3
(STEL)
ppm
(STEL)
mg/m3 ppm
TWA
(TWA) (TWA) Footnote
Water
Hydrochloric Acid
7.5
5
Peak
(Hydrogen Chloride)
Limitation
Phosphoric Acid
3
1
Ingredients
determined not to be
hazardous
Ensure that the ventilation is adequate to
maintain air concentrations below the exposure
standard. If necessary, provide corrosion
resistant local exhaust ventilation, exhausting
to the outside of the building. Do not enter
confined spaces where the vapour may have
accumulated.
Wear PVC gloves, chemical goggles and/or a face
shield and enclosed footwear. An acid resistant
full face respirator to AS 1716 is recommended if
vapours or spray mists are produced during use.
It is recommended that overalls or a shirt with
long sleeves and long trousers be worn, along
with an apron. Always wash skin and clothing
after using this product.
9. PHYSICAL AND CHEMICAL PROPERTIES
Form
Appearance
Boiling Point
Solubility in
Water
Specific Gravity
pH Value
Evaporation
Rate
Volatile
Component
Flash Point
Flammability
Liquid
Clear deep blue slightly viscous liquid, pleasant
pot pourri fragrance.
100°C
Complete
1.045 @ 25°C
Approximately 1
As for Water
85.6 % w/w
This product will not flash.
This product is not flammable and does not
support combustion. However, this product may
liberate Hydrogen gas on contact with metals,
thus creating a fire and explosion hazard.
Potential sources of ignition should be excluded
from the immediate area.
10. STABILITY AND REACTIVITY
Chemical
Stability
Conditions to
Avoid
Incompatible
Materials
Hazardous
Decomposition
Products
Hazardous
Polymerization
Considered stable to heat and light, however for
improved shelf life store below 30°C and keep out
of direct sunlight.
None known.
Soaps, detergents, anionic surfactants, alkaline
materials, strong oxidising agents.
Chlorine gas is a possible decomposition product.
During combustion, this product may produce
carbon monoxide as well as other unidentifiable
organic compounds.
Will not occur.
11. TOXICOLOGICAL INFORMATION
Vapours and spray mists are irritating to the
nose, throat and respiratory tract. Excessive
exposure to vapours may cause lung damage.
May be harmful if swallowed. May cause chemical
Ingestion
burns to the mouth and digestive tract. May cause
dysphagia (inability to swallow), nausea,
vomiting, intense thirst and diarrhoea.
May cause severe burns. May cause tissue
Skin
necrosis. May cause skin irritation.
May cause eye irritation. Contact with the eye
Eye
may cause corneal damage.
Chronic Effects No known chronic effects.
None of the components of this product is known
Reproductive
to have developmental or reproductive effects.
Toxicity
None of the components of this product is known
Mutagenicity
to be a mutagen.
Carcinogenicity None of the components of this product is known
to be a carcinogen.
None of the components of this product is known
Skin
to be a skin or respiratory sensitiser.
Sensitisation
Inhalation
12. ECOLOGICAL INFORMATION
Short Summary
of
Assessment of
Environmental
Impact
All of the surfactants used in this product are
ultimately biodegradable. One of the nonionic
surfactants is a marine pollutant, but at its
concentration of less than 1% in this product and
considering the level of dilution experienced
when this product is used and the
biodegradability of the surfactant, it is not
expected to exhibit undue levels of toxicity in
the aquatic environment.
High concentrations of this product in receiving
waters will also injure aquatic life due to the
effect of low pH. Therefore, the undiluted
product should be prevented from entering
waterways. The expended material should be
drained to the sewer as sewerage treatment will
greatly reduce damage to water quality.
13. DISPOSAL CONSIDERATIONS
Product
Disposal
Dispose of large amounts in a chemical dump
according to local authority statutory
requirements. For small quantities, allow
controlled access to the effluent system.
Container
Disposal
Rinse empty containers with an excess of water to
the effluent system. The clean, empty containers
are recyclable.
14. TRANSPORT INFORMATION
U.N. Number
Proper Shipping
Name
DG Class
Hazchem Code
Packaging
Method
Packing Group
IERG Number
IMO Marine
Pollutant
3264
CORROSIVE LIQUID, ACIDIC, INORGANIC, N.O.S. (Contains Hydrochloric acid and Phoshoric Acid)
8
2X
3.8.8
III
37
Not classified as a Marine Pollutant, according
to the International Maritime Dangerous Goods
Code.
15. REGULATORY INFORMATION
Poisons
Schedule
Hazard
Category
AICS
(Australia)
S5
Harmful,Corrosive
To the manufacturer's best knowledge, all of the
components of this product are listed on AICS
(Australian Inventory of Chemical Substances).
16. OTHER INFORMATION
Contact
Person/Point
Other
Information
Technical Manager (07) 3390 5044
The amphoteric surfactant used in this product is
readily biodegradable and is classified as
biologically soft. The biodegradability of the
quaternary ammonium compound is not covered by
AS1792-1976. However, it is cationic in nature
and as such is rapidly removed from effluents by
absorption onto suspended particles and by
interaction with the large excess of anionic
surfactants commonly present. In the absence of
the above factors, biodegradation will still
occur reasonably rapidly at low concentrations.
...End Of MSDS...
(C) Copyright ACOHS Pty Ltd
Copyright in the source code of the HTML, PDF, XML, XFO and any other electronic files rendered by an Infosafe system for
Infosafe MSDS displayed is the intellectual property of Acohs Pty Ltd.
Copyright in the layout, presentation and appearance of each Infosafe MSDS displayed is the intellectual property of Acohs Pty Ltd.
The compilation of MSDS's displayed is the intellectual property of Acohs Pty Ltd.
Copying of any MSDS displayed is permitted for personal use only and otherwise is not permitted. In particular the MSDS's
displayed cannot be copied for the purpose of sale or licence or for inclusion as part of a collection of MSDS without the express
written consent of Acohs Pty Ltd.