SUPPILER NAME:
COMMERCIAL PRODUCT NAME:
O & P Enterprises
3989 Grove Ave.
Gurnee, IL 60031
OPFlex
Typical Uses
CHEMICAL CONSTITUTION OF
PRODUCT:
PHYSICAL PROPERTIES:
Sheet for Thermoforming
Propylene/Ethylene Co-Polymers
Boiling Point
NA
Vapor Density
NA
Vapor Pressure @ 20 C
NA
pH
NA
Solubility in Water
Negligible
Melting Point
>248 F (120 C)
Specific Gravity (Water = 1)
0.88 - 0.92
% Volatile (Vol.)
<.04
Evaporation Rate
NA
Form
Solid Pellets or Powdery Solids
Appearance
Sheets
Color
White (Natural)
Odor
STORAGE AND HANDLING:
Precautions During Storage and Handling:
Slight waxy odor
Hazardous Combustion and Decomposition
Products:
Disposal Procedures:
Individual Preventive Measures:
IGNITION AND EXPLOSION:
Flash Point:
Auto-Ignition Temperature:
Special Fire, Explosion Hazard:
Stability Considerations:
Extinguishing Media:
Special Fire Fighting Instructions:
FIRST AID PROCEDURES:
Inhalation:
Skin Contact:
Eye Contact:
Ingestion:
ENVIORMENT PROTECTION:
SPECIFIC DATA:
PHONE: 800.666.0356
Keep away from sparks and open flames. This product may react with strong oxidizing
agents and should not be stored near such materials. Advisable t store in sprinklered
warehouse. Keep temperature below 140 F (60 C) for quality control.
Hazardous products of combustion are carbon dioxide and carbon monoxide.
Incompatible with strong oxidizing agents. No known decomposition products.
Hazardous polymerization will not occur.
Incineration of waster material in a permitted facility in accordance with local, state and
federal regulations is a suitable alternative.
There are no known health hazards and this material is not expected to cause
physiological impairment at low concentrations. However, it is recommended that this
material be treated as a nuisance dust or particulate in accordance with the
recommendations of ACGIH.
Eye contact: It is recommended that protective eyewear is worn. If material comes in
contact with the eye, wash carefully. If problem persist, seek medical attention. Skin
Contact: Heated material could cause thermal burns. Use of gloves/clothing is good
practice. Inhalation: No significant irritation Use with adequate ventilation. If general
ventilation is inadequate, local exhaust ventilation should be used to dispose of vapors
from hot processing equipment. Ingestion: No significant health hazards indentified.
>625 F (329 C)
>675 F (357 C)
Products as shipped are not a flammable dust. However it can be a flammable dust
when fines are suspended in air.
Stable
Water spray, dry chemical, foam, or carbon dioxide.
Standard procedures for Class A fires.
If adverse effects occur, remove to uncontaminated area and get medical attention.
Wash exposed skin with soap and water. Do not try to remove hot plastic from skin.
Removal could cause serious damage. Get medical attention.
Flush eyes with plenty of water.
If a large amount is swallowed, get medical attention.
To be disposed of in accordance with the appropriate legislation.
Transport: not regulated