ozone generator

advertisement
4.1 Applications:
Ozone Generators GO007, GO014 and GO021 are designed to perform specific intensive
ozone treatment in order to disinfect, deodorize, renew and purify air, textiles, furniture,
carpets and so on.
Do not remain in the room while the ozone generator in running. If you enter the room while
the machine is generating ozone you will immediately notice its odor, leave immediately and
close the door.
Application examples:
• Daily cleaning of hotel rooms, nursing homes, hospitals.
• Odor Removal of paint.
• Timely disinfection of waiting rooms and operating theaters.
• Disinfecting and deodorizing vehicles and public transport.
• Elimination of burnt and soot smells.
5. How to use
Example: Deodorization of a hotel room
1. Place the generator in the room at a height not less than 220 cm with the output
zone of the machine towards the center of the room.
2. Set the desired treatment time, available between 0 and 30 minutes.
3. Turn the system on, leave the room and do not enter until the programmed time
has elapsed.
4. Once finished, ventilate the room or stay out until the double of the treatment
time has passed.
The needed time to achieve the target will depend largely on the amount and type of
contamination to be removed. However, in the following table, the times are indicated in minutes
for normal treatment needed per 50 m3 of the room to be treated.
APPLICATIONS
Generation capacity
Housekeeping
Vehicle disinfection and deodorization
Deodorizing Clothes
Deodorization of burned environments
Paint Odor Removal
HIGH
7 g/h 14 g/h
3
1,5
5
3
15
10
20
10
30
15
Contamination
MEDIUM
7 g/h 14 g/h
1,5
1,5
3
2
10
5
15
10
20
10
LOW
7 g/h 14 g/h
1,5
1,5
2
1,5
5
3
10
5
10
5
720001-C vA
U
S
E
R
M
A
N
U
A
L
OZONE GENERATOR
GO007 – 7 g. Ozone / hour
GO014 – 14 g. Ozone / hour
GO021 – 21 g. Ozone / hour
Vernis Motors, S.L.
Tel. (+34) 93 710 52 68
[email protected]
www.vernismotors.com
User manual
OZONE GENERATOR: GO007, GO014 i GO021
Classification: Type A
OZONE GENERATOR -TECHNICAL FEATURES
Model
GO014
Ozone produxtion
Before starting the initial setup and installation, read this manual carefully.
1. Installation
1.
2.
3.
4.
5.
It is convenient to place the ozone generator at a height level not less than 220
cm and its installation must always be performed by technical specialists.
Installations that require large production must be equipped with an ozone
detection system and alarm.
The generator must be adapted to the room or conduct to be treated and should
not be used for other applications not studied in the project.
Ozone generators can be used and / or installed in areas where other ozone
production sources exist, always making sure that the ozone emission levels are
not exceeded.
The entrance to an ozone area must be adapted with warning signs.
2. Safety
To install this machine, do not rush, act correctly, be responsible and follow the instructions
below:
1.
2.
3.
4.
5.
6.
7.
8.
This generator cannot be used in the presence of people or animals.
Do not change the established area without consulting a specialist.
Do not install in places where chemical products are handled.
Ozone can be irritating at levels higher than 200 mg / m3.
Avoid inhaling ozone.
After the treatment remember to ventilate the room or leave it sealed at least the
double of the treatment duration time.
Do not introduce any objects through the ventilation holes of the machine.
Do not cover or obstruct the air output holes of the generator.
The manufacturer declines all responsibility for any damage resulting from improper
usage of the machine or failure using the indicted instructions.
Features
You have purchased an ozone generator equipped with a high frequency corona discharge
technology system, specially designed for intensive treatments in various environments
(offices, textiles, food, furniture, etc).
Electrical
Physical Features
Others
Oxygen Contribution
Production Capacity
Air treatment
Air output
Production variation
Ozone Output
Power supply
Power Consumption
Protection
Size
Weight
Control
GO007
Air ambient
14 g/h
14 g/h
Filtered
120 m3/h
15 %
Direct
230 V, 50-60 Hz
220 W
220 W
Fuse 4 A
30 cm x 25,5 cm x 23,5 cm
6,5 kg
6,5 kg
Switch ON / OFF
Other notable features of Vernis Motors Ozone Generators are:
•
Ozone generation through high frequency discharge.
•
Generator classified as Type A efficiency.
•
Direct Discharge.
•
Stainless steel housing with earth grounding.
•
Manufactured with sturdy and durable materials.
•
Forced ventilation by extraction.
•
Internal adjustable Cycle.
•
Simple connection.
The ozone generator is equipped with protections and security that prevents direct and
indirect contact with the live parts (in tension) of the machine. The machine is also provided
with protections against over-current (fuse).
Operation:
Activating the power switch the machine automatically starts generating ozone. Once the
treatment time has elapsed the system stops. The treatment time can be regulated by the
timer situated on the front control panel.
4. Working conditions:
•
•
•
•
•
•
Temperature between 5 ° C and 40 ° C.
Humidity less than 60%.
Dust concentration below 1 mg / m3
Do not use in high humidity environments.
Do not use in greasy environments.
Do not use in explosive environments.
Download
Related flashcards

Respiratory therapy

17 cards

Bronchodilators

17 cards

Antitussives

52 cards

Antitussives

54 cards

Create Flashcards