Testing:
1. What products emission reductions in emissions are reduced with the
use of liquefied natural gas:
a) hydrocarbon, soot;
b) products of complete combustion;
c) the products of incomplete combustion
g) 3,4 benzopyrene;
d) carbon monoxide and sulfur dioxide.
2.What impurity emissions are reduced when using gaseous fuels:
a) formaldehyde, styrene;
b) aldehydes, oxides of nitrogen;
c) carbon black, 3,4 benzopyrene;
d) carbon monoxide and hydrocarbons;
d) alcohols, phenol aldehyde.
3. What is necessary for the normal operation of the electrostatic
precipitator:
a) additional pollution flue gas;
b) raising the temperature of the flue gas;
c) drying the flue gas;
d) mechanical cleaning before the electrostatic precipitator;
d) humidifying.
4.Koeffitsient efficiency electrostatic precipitator:
a) 40%;
b) 50%;
c) 65%;
d) 75%;
d) 99%.
5.Nazovite highly efficient ash collector:
a) cyclone myotome;
b) SIOT cyclone;
c) a scrubber;
g) louver ash collector;
d) precipitator.
6.Nazovite getter devices for SO2 with an efficiency of 90%:
a) a water scrubber;
b) lime scrubber;
c) scrubber magnesite;
g) ammonia scrubber;
d) louver ash collector.
7.Osnovnye reasons for planning actions:
a) Identification of hazardous wind speed and direction;
b) the development of the wind rose and gassed;
c) functional zoning of settlements;
d) selection of sites for the construction industry;
d) Development of regional planning schemes of the city.
8. As the event evaluates the degree of contamination and / in:
a) sanitary;
b) technology;
c) legislative;
d) rational and radical;
d) planning and technology.
9. What is a protective barrier from industrial emissions:
a) screens;
b) green spaces;
c) loose buildings;
g) and lower case series;
d) perimeter building.
10. What should be a break for warehouses dusting materials:
a) not less than 25m;
b) not less than 30m;
c) not less than 40m;
d) not less than 50m;
d) not less than 100m.
1. What sources is subject to the CH 245-71 and 006-93 SanPin
a) the company emit noise and vibration of the microorganism
b) the company is an energy and emit pollutants common
c) the company being the source of specific pollutants.
d) the company being the source of pollution and noise, EMI.
2. Subject to any natural conditions necessary to select the site for the
construction of industrial plants
a) solar radiation areas of ventilation, dilution and self-purification of air
b) aeroclimatic conditions, wind speed, temperature, height of chimneys
c) aeroclimatic conditions, terrain, solar radiation, ventilation and
dispersion processes substances in the atmosphere.
d) self-purification processes of dispersion, the availability of effective
dust and gas cleaning facilities.
3. Where part of the SPZ in terms of the village
a) the balance sheet commuters
b) the balance of the industrial zone
c) the balance sheet throughout the city
d) the balance sheet communal storage area
d) in the balance of the transport zone.
4. What kind of air pollutants more breaks sanitary conditions.
a) sulfur dioxide
b) hydrocarbons
c) a nitrogen oxide
d) carbon monoxide
d) suspended solids
5. Why do we need to simultaneously study the weather conditions of
the atmosphere.
a) geographic images "roses"
b) to determine the cause and the transfer of pollution concentration in
normal weather conditions
c) for estimating the degree of contamination and proliferation
d) to evaluate the effectiveness of treatment facilities.
d) to compare their own research with the HMS.
6. What actions sanitary doctor should be in excess of the concentration
of substances regulations.
a) the authorization of the violation and imposing a fine
b) assessment of health and sanitary violations
c) criminal prosecution
g) to determine the causes, and the elimination of their conduct
recreational activities
d) re-air tests using other methods
7. Where are placed industry sources.
a) in the city
b) in the buffer zone
c) in the zone of the external transport
g) in industrial area
d) the administrative center
8. Which method of examination is the study of the location of the
object in terms of the village.
a) laboratory
b) instrumental
c) Sanitary and topographical
d) sanitary-epidemiological
d) Sanitary
9. What are the issues which characterize the sanitary topographical
source location when Sanitation.
a) Emissions organized and unorganized, toxicity of the substance, the
height of the roof
b) the height of chimneys, number of storeys, the height of the
foundation
c) the source state of groundwater, the presence of sewage
d) the place of the object, the width of the SPZ, enterprise class size of
the area functional zoning
d) sealing and automation of technological processes, industrial water
supply source
10. Sanitary inspection of the residential area near the plant Tashselmash
to a survey of the population indicated that 50% of those interviewed
noted the difficulty airing apartments. Specify what kind of influenced
by plant emissions Tashselmash.
a) chronic
b) direct
c) indirect
d) acute
e) moderate
1. Which of the sources emits products and incompletely burned ashes
a) prom. enterprise
b) the construction industry
c) transport
g) CHP
d) soil
2. Factors affecting the degree of air pollution
a) the means and methods of determining the pollution in the air
b) the mode of operation of the source, emissions, air temperature, wind
speed and direction
c) chemical and physical properties of harmful substances
g) the proximity of the source, the lack of green spaces and hot emission
e) trans location and transformation of substances
3. What tests enjoys in practice health surveillance of air pollution
a) the average daily and monthly
b) monthly and annual
c) one-off, the maximum single and daily average
d) pink, annual and monthly mean
e) the arithmetic mean and unambiguous
4. We studied the air on the border of the living and sanitary protection
zone and found a 2-fold excess of the MCL ammonia. What disease can
thus detect
a) violation of health
b) changes premorbitnye
c) mortality and premorbid state
g) disease of unknown etiology
d) diseases of known etiology
5. In a residential area near the boiler room air was investigated and
found sulfur dioxide and nitrogen dioxide at each MPC. What effect the
action of these substances have and what they should be equal to the
sum of
a) The effect of antagonism and their sum must be equal to 0.5
b) the effect of summation of their sum does not exceed 1
c) the effect of potentiation and their sum is equal to 1.5
d) the effect of summation and potentiation and their amount should hit
1.5
d) the effect of potentiation and antagonism and their sum is equal to 2
6. studied air on kozhmehzavode. From sewage treatment plants has a
cyclone. Why vote in the air acetic acid vapors exceed MAC
a) Acetic acid is more volatile
b) acetic acid is continuously in air
c) there are no treatment facilities of purification of acetic acid vapor
d) plant located within the residential area
d) there is a treatment plant cyclone
7. List the main sources of air pollution
a) general and specific sources
b) vehicles, special medical institutions
c) prom. businesses, cultural and service establishments
g) the field of composting, irrigation fields
e) prom. businesses, vehicles, soil CHP
8. Where Stir industrial sources
a) in the city
b) in the buffer zone
c) in the zone of the external transport
g) in industrial area
d) the administrative center
9. What are the methods of study carried out at the source of air
pollution
a) tools, sanitary, epidemiological
b) the rank of technical, laboratory and population survey
c) the rank-and-hygienic, epidemiological, instrumental
d) aspirating, sedimentation and weight
d) sanitary topographical, engineering and San San epidemiological
10. What questions characterizing San topographic source location when
Sanitation
a) Emissions organized and unorganized, toxicity of the substance, the
height of the roof
b) the height of chimneys, number of storeys, the height of the
foundation
c) the source state of groundwater, the presence of sewage
d) the place of the object, the width of the SPZ, enterprise-class, plot
size, functional zoning
d) gemetizatsiya and automation of technological processes, industrial
water supply source
1. The value of the air temperature changes (gradient height premises)
shall not exceed:
a) 1-2 ° C;
b) 2 ° C;
a) 1-3 ° C;
g) 1-5 ° C;
d) not more than 5 ° C.
2. The magnitude of fluctuations in air temperature (gradkyat horizontal)
shall not exceed:
a) 2-3 ° C;
b) 2-4 ° C;
a) 1-5 ° G;
g) 3-5 ° C;
d) not less than 5 ° C.
4. What instrument is determined um ^ nsivnest natural light?
a) Golyuksmetrom U-116;
b) U-116 light meter, ruler Danyluk;
c) U-116 light meter, ruler Danyluk and the same schedule;
g) U-116 light meter, ruler and graph Danyluk, lighting angle;
e) determining the angular lighting, angles holes in the lineup and
schedule Danyluk.
5. Specify the angle of incidence of the standards?
a) not more than 10 °;
b) at least 25-27 °;
c) not less than 20-27 °;
d) not less than 27 °;
d) not less than 20-28 °.
6. Specify whether the Lighting method used to assess the natural
lighting in living rooms and its standards for side lighting?
a) determining KEQ and its norm is less than 0.5%;
b) the definition of KEO and its norm of 0.5%;
c) determination of the UK and its rate of 0.5%;
g) the definition of KEO and its norm 0.1-0.5%;
d) determination of the UK and its rate of not less than 0.5%.
7. By what formula determined KEO
EB 100%
a) KEO = ------------------Yong
Eo 100%
b) KEO = ------------------Yong
E 100%
c) KEO = ------------------Yong
E 100 N
g) KEO = ------------------Eo
d) KEO = ew m
8. According to the project floor area of 16 m2, glazed pane 2 m2.
Determine the UK this room.
a) 1: 8.5;
b) 1: 9;
a) 1:10;
g) 1:18;
e) 1: 8.0.
9. The level of artificial light at 15-20 m2 floor space is measured:
a) 5-10 points;
b) 8-10 points;
c) 5-12 points;
g) 5-15 points;
d) at 15 points.
10. The level of artificial light in a residential area shall be:
a) at least 50 lux;
b) at least 80-100 lux;
c) at least 50-100 lux;
d) not less than 100 lux;
d) not less than 50-150 lux.
1. build a factory 3-class residential area in relation what issues need to
be addressed when placing.
A) rose gassed, composition Vod, the width of the SPZ
B) The wind rose direction of flow of the river to determine the size of
the SPZ
B) once dust, chimney height and capacity of the enterprise
D) planning sanitary measures.
D) the organizational, technological measures
2. What should be a gap for warehouses dusting materials
A) not less than 25 m.
B) not less than 30 m
B) not less than 40 m
D) not less than 50 m
D) at least 100 m
.
3. At what distance is established buffer zones for powerful industrial
complexes
A) 500- 1000 m.
B) to 1000 m
B) 1000 - 2000 m
D) 2000 - 5000 m
D) 10,000 - 20,000 m.
4. What kind of air pollutants more breaks san. living conditions.
A) sulfur dioxide
B) hydrocarbons
B) a nitrogen oxide
D) Carbon monoxide
D) suspended solids
5. Which of the sources emits unburnt carbon and ash products
A) industrial enterprises.
B) construction enterprises
B) transport
D) CHP
D) soil
6. What is the maximum height of surface inversion
A) 200-300
B) 301-400
B) 401-500
D) 501-600
D) 601 and more
7. What is the maximum height of the elevated inversion
A) 500 m
B) 800 m
C) to 1000 m
D) to 1500 m
D) 2000 m
8. Which of the inversions contribute to indirect impact on health
A) Surface
B) high
B) the adiabatic
D) sedimetatsionnaya
D) aspiration
9. At what level is set MAC harmful substances in the air
A) at steps
B) at the level of causing chronic effects
B) at the level of cause acute effects
D) on subliminal effect
D) on the subliminal level
10. How many of the principles are the basis of the valuation of harmful
substances in the air.
A) 2
B) 3
B) 4
D) 5
D) 10