LPDE MSDS Sheet

advertisement
SUPPILER NAME:
COMMERCIAL PRODUCT NAME:
O & P Enterprises
3989 Grove Ave.
Gurnee, IL 60031
Low Density Polyethylene
Typical Uses
CHEMICAL CONSTITUTION OF
PRODUCT:
PHYSICAL PROPERTIES:
Sheet for Thermoforming
Boiling Point
NA
Flash Point
F: NA - C: IP 170/70
Relative Density
15/4 C: 1.33
Vapor Pressure
mm Hg 20C: NA
Viscosity at 100F
Sus: NA At 40C, CS: NA
Viscosity at 210F
Sus: NA At 100C, CS: NA
Solubility in Water
Nil
Melting
110 C/230 F
Form
Translucent Pellets
Apperance
Sheets
Color
White(Natural)
Odor
STORAGE AND HANDLING:
Precautions During Storage and Handling:
Mild
Hazardous Combustion and Decomposition
Products:
Disposal Procedures:
Individual Preventive Measures:
Symptoms of Over-Exposure:
PHONE: 800.666.0356
Polyethylene 100%
Avoid extreme heat and strong oxidizers, Store in a cool area. Good personal Hygiene
and safe work practices should always be followed when handling this product. For
industrial use only. Not intended for use in or around a household dwelling.
Carbon monoxide, aldehydes, acetic acid. Hazardous polymerization will not occur.
Shovel and dispose as normal refuse. Product is suitable for burning in an enclosed,
controlled burner for fuel value or disposal by supervised incineration. Such burning may
be limited pursuant to the resources conservation and recovery act. Use of these methods
is subject to use compliance with applicable laws and regulations and consideration of
product consideration of product characteristics at the time of disposal.
Normal industrial eye protection practices should be employed. Gloves are required to
handle hot materials. Approved dust respirators must be used for dusty conditions of use
and with adequate ventilation. Use local exhaust over heating operations. No special
requirements under ordinary conditions of use and with adequate ventilation.
Inhalation of fines, if any, can cause irritation of nose and throat. Pellets and fines, if any,
may cause abrasive injury and irritation to eyes. (Threshold limit value: 10.00 mg/m3
suggested for nuisance dusts.)
IGNITION AND EXPLOSION:
Flash Point:
F: NA – C (IP 170/70)
Flammable Limits (LEL & UEL):
NA
Special Fire, Explosion Hazard:
High dust levels may create potential for explosion. Exposure to fire can generate highly
toxic fumes.
Carbon dioxide, foam, dry chemical and water fog.
Extinguishing Media:
Special Fire Fighting Instructions:
NFPA Hazard ID:
Wear a NIOSH approved positive pressure self contained breathing apparatus and
firefighter turnout gear. Use flooding quantities of water until well after fire is out.
Health: 1, Flammability: 0, Reactivity: 0
FIRST AID PROCEDURES:
Inhalation:
Not expected to be a problem.
Skin Contact:
Eye Contact:
If burned by contact with hot material, cool molten material adhering to skin as quickly
as possible with water, and see a physician for removal of adhering material and
treatment of burn. Wash contact areas with soap and water.
Flush with water.
Ingestion:
Not expected to be a problem. If uncomfortable seek medical assistance.
Download