QUICK QUIZ 26.1
(end of section 26.2)
The volume enclosed by the plates of a parallel plate
capacitor is given by the equation Volume = Ad. If one
doubles the area, A, of the plates and reduces the plate
separation, d, by a factor of two so that the volume remains
the same, the capacitance will a) decrease by a factor of 4, b)
decrease by a factor of 2, c) remain constant, d) increase by a
factor of 2, or e) increase by a factor of 4.
QUICK QUIZ 26.1 ANSWER
(e). Because the capacitance is determined by Equation 26.3,
C = eoA/d, doubling the plate area and decreasing the plate
separation by a factor of two will increase the capacitance by a
factor of 4.
QUICK QUIZ 26.2
(end of section 26.2)
You are given a certain area of plate material to construct either a
parallel plate or spherical capacitor. To maximize the capacitance,
you will make the plate separation, d, as small as possible but are
limited to a minimum value to avoid dielectric breakdown. Assume
that the plate separation will be much less than the dimensions of the
plates (e.g. d is much less than the radius of either sphere of the
spherical capacitor). Also, you will use the same area of plate
material and use the same plate separation for each capacitor. You
will find that the capacitance of the spherical capacitor is a)
significantly less than the capacitance of the parallel plate capacitor,
b) about the same as the capacitance of the parallel plate capacitor, c)
significantly more than the capacitance of the parallel plate capacitor,
or d) impossible to compare without knowing the precise dimensions
of the parallel plate and spherical capacitor.
QUICK QUIZ 26.2 ANSWER
(b). For the parallel plate capacitor, Cp = eoA/d = A/(4pked).
For the spherical capacitor, Cs = ab/(ke(b-a)) = ab/(ked). For
d << a, ab ~ a2 ~ b2. Using the same plate area for the
spherical capacitor as the parallel plate capacitor implies, A =
4pa2 ~ 4pb2 ~ 4pab. Therefore ab ~ A/4p and Cs ~ A/(4pked);
identical to the formula for the parallel plate capacitor.
QUICK QUIZ 26.3
(end of section 26.2)
As was shown in Example 26.3, the capacitance of a spherical capacitor is
given by the expression C = ab/(ke(b - a)), and in the limit that the radius of the
outer spherical shell goes to infinity, the capacitance is given by C = a/ke.
Assume instead that you have a spherical capacitor of plate radii a and b and,
while keeping the radius of the outer spherical shell constant, you let the radius of
the inner spherical shell go to zero. In this limit, the formula for the capacitance
would be
a) C = b/ke
b) C = a/ke
c) C = (b - a)/ke
d) C = (b + a)/ke
QUICK QUIZ 26.3 ANSWER
(b). From the expression C = ab/(ke(b - a)), dividing top and
bottom by b yields C = a/(ke(1 - a/b)). In the limit that a is
much less than b, whether it is because b goes to infinity or
because a goes to zero, you still wind up with the same
expression, C = a/ke.
QUICK QUIZ 26.4
(end of section 26.3)
A very large capacitor is in series with a very small
capacitor. The equivalent capacitance of this combination
will be a) slightly greater than the capacitance of the large
capacitor, b) slightly less than the capacitance of the large
capacitor, c) slightly greater than the capacitance of the
small capacitor, or d) slightly less than the capacitance of
the small capacitor.
QUICK QUIZ 26.4 ANSWER
(d). Using Equation 26.10 for two capacitors in series,
1
1
1


Ceq Cbig Csmall
CbigCsmall
Csmall
or Ceq 

Cbig  Csmall 1 Csmall Cbig
Since Csmall/Cbig is a small number, the denominator will be just
slightly greater than 1, and the equivalent capacitance will therefore
be slightly less than the capacitance of the small capacitor.
QUICK QUIZ 26.5
(end of section 26.5)
Three of the materials from Table 26.1 are listed below. Assume you perform an
experiment where you charge up the plates of a parallel plate capacitor with a battery to
a certain charge, Qo and voltage, Vo. You then remove the wires between the battery and
the capacitor. You then successively place each of the three dielectric materials between
the capacitor plates. In each case, the dielectric material is made to completely fill the
region between the plates. The material that will be least likely to undergo dielectric
breakdown will be a) neoprene rubber, b) polyvinyl chloride, c) Teflon, or d) impossible
to determine without knowing the dimensions of the capacitor.
Material
Dielectric Constant k
Dielectric Strength (106 V/m)
Neoprene rubber
6.7
12
Polyvinyl chloride
3.4
40
Teflon
2.1
60
QUICK QUIZ 26.5 ANSWER
(b). Dielectric breakdown occurs when the maximum electric field
(dielectric strength) is reached. Therefore, you would like to choose a
material with a high dielectric strength. However, since the capacitor is
disconnected from the battery, the voltage will decrease by a factor of k
when the dielectric is introduced. In addition, since the electric field is
related to the voltage by DV = Ed, the electric field also is reduced by a
factor of k. You would therefore also like to maximize k so that the electric
field encountered by the material is reduced. We want the encountered
electric field, E, to be less than the maximum electric field (dielectric
strength), Emax. We know that E = DVo/kd and we want Emax > E or Emax >
DVo/kd or k Emax > DVo/d. Therefore, we would like to maximize the
product k Emax and this is a maximum for polyvinyl chloride.