Programming instructions.
To set the time
Pool pump and heat pump must be ON.
Pictrue 1
Picture 2
Picture 3
1. Press <CLOCK>, the hour will flash (picture 1)
2. To adjust the first two numbers press a second time on <CLOCK> and press on the arrow
up
or down to set the time. (picture 2)
3. To adjust the minutes push a 3rd time on <CLOCK> to make the minutes flash, and push
the arrow up
or down
to set the minutes. (picture 3)
4. Push one last time on <CLOCK> to confirm the time.
Please note you will have 3 to 4 seconds between each step to complete the adjustments.
Start the heat pump.
The pool pump must be ON.
Picture 1
Picture 2
Picture 3
1. When the breakers is ON you will see this ( Picture 1)
2. To start the heat pump, start your pool pump first and next your heat pump,
see (Picture 2)
3. You will then see the water temperature appear. To increase water temperature
Example: 68 then push on the up arrow (Picture 3)
To set the Timer
Pool pump and heat pump ON.
Picture 1
Picture 2
Picture 3
1. To set the timer according to operating mode press the TIMER ON figure 1)
2. To set the start time of the heat pump press a second time TIMER ON, the first two digits
will flash, adjust by pressing
or
arrows , press a third time on TIMER ON to adjust
the minutes. (Picture 2)
3. Press one last time on TIMER ON to confirm your choice. (Picture 3)
4. Repeat steps 1 through 3 for the TIMER OFF.
Please note you will have 3 to 4 seconds between each steps to complete the adjustments.
Removing the timer.
Pool pump and heat pump ON.
Picture 1
Picture 2
Picture 3
1. To remove the timer (ON & OFF) press TIMER ON, the numbers will flash
then press on CLOCK. ( Picture 1 & 2 )
2. Repeat procedure for the timer OFF (Picture 3)
Please note you will have 3 to 4 seconds between each step to complete the
adjustments .
To return to factory settings.
Pool pump ON and heat pump OFF.
Picture 1
Picture 2
Picture 3
1. Put the heat pump on stand-by press on
2. Press at the same time MODE & CLOCK for about 3 seconds (Picture 1 )
3. Press the left arrow to see the parameters 0 to 9 and the parameters
a,b,c,d,e, and compare them with those in your owner’s manual. (Picture 2)
4. If there are differences, select the setting to be changed from 0 to 9 press on
MODE and
at the same time and press on an arrow to change the numbers.
( Picture 3 )