CSWA
http://www.eng.uwo.ca/designcentre/CAD%20resources/default.htm
1
DIMENSIONING AND TOLERANCING
2
prismatic.sldasm
3
DIFFERENT TYPES OF FIT
Clearance fit
Limits of size defined such that a clearance always
results when mating parts are assembled
Interference fit
Limits of size are so prescribed that interference
always results when mating parts are assembled.
Transition fit
Limits of size are so prescribed that either clearance or an
interference may results when mating parts are assembled
Line fit
Limits of size are so prescribed that surface contact or
clearance may result when mating parts are assembled
4
BASIC HOLE SYSTEM
In the basic hole system the minimum (lower limit) hole size is taken as the basic size.
Stock hole is made “first” and then shaft is made to particular type of fit (to suit the hole).
5
BASIC SHAFT SYSTEM
In the basic shaft system the maximum (upper limit) shaft size is taken as the basic size.
Stock shaft is created “first” and hole is made to particular type of fit (to suit the shaft).
6
BASIC SHAFT OR BASIC HOLE?
In the basic hole system the minimum (lower limit) hole size is
taken as the basic size.
Stock hole is made “first” and then shaft is made to particular type
of fit (to suit the hole).
In the basic shaft system the maximum (upper limit) shaft size is
taken as the basic size.
Stock shaft is created “first” and hole is made to particular type of
fit (to suit the shaft).
7
IDENTIFY FIT SYSTEM
“Shaft”
“Hole”
-
=
=
What type of fit is this?
8
IDENTIFY FIT SYSTEM
9
IDENTIFY FIT SYSTEM
Basic hole
Basic shaft
More commonly used
Less commonly used
10
IDENTIFY FIT SYSTEM
Shown are limit tolerances
11
Surface roughness for different manufacturing methods
http://mdmetric.com/pdf/surfruff.pdf
12
13
Φ
Basic hole fits
14
Φ
Basic shaft fits
15
Description of preferred fits
16
ANSI PREFERRED HOLE BASIS METRIC CLEARANCE FITS
Pages 312, 313, 314, 315
ANSI PREFERRED SHAFT BASIS METRIC CLEARANCE FITS
Pages 316, 317, 318, 319
Engineering Design Graphics
James Leake
Jacob Borgerson
17
Nominal
diameter 25mm
Btw. what is wrong
with this assembly?
cylindrical_metric.sldasm
18
Loose running fit for nominal diameter 25mm preferred hole basic
19
Free running fit for nominal diameter 25mm preferred hole basic
20
Close running fit for nominal diameter 25mm preferred hole basic
21
Sliding fit for nominal diameter 25mm preferred hole basic
22
Locational clearance (line fit) for nominal diameter 25mm preferred hole basic
23
Locational transition fit for nominal diameter 25mm preferred hole basic
24
Locational transition fit for nominal diameter 25mm preferred hole basic
25
Locational interference fit for nominal diameter 25mm preferred hole basic
26
Medium drive fit for nominal diameter 25mm preferred hole basic
27
Force fit for nominal diameter 25mm preferred hole basic
28
Hole is always the same: H7
We obtained the desired fit by changing shaft tolerance
29