Course Approval Form
Subject Code: ES-1002
Course Title: Fundamentals of Electrical and
Electronics Engineering
Contact Hours: L-3 , T-0, P- 2
Credit: 5
Programme: B.Tech.
Semester: II
Course type: Core
Course Open to: UG
Pre-requisites: Nil
Evaluation scheme
Quiz I (10%), Mid-Term (25%), Quiz II (10%), End-Term (35%), Lab (20%)
Module I
10H
D.C. Circuits: Ohm’s law, Kirchoff’s laws, Nodal Analysis, Mesh Analysis, Superposition Theorem, Source
Transformations, Thevnin’s and Norton’s Theorems, star/delta transformation, maximum power transfer
theorem, Transients.
Module II
10H
A.C. Fundamentals: Single phase EMF generation, average and effective values of sinusoids, Solution of
series and Parallel Circuits, power and power factor, Resonance in series and parallel circuits, steady state
analysis for sinusoidal excitation: Sinusoids, Three phase connections: star and delta.
Module III
12H
Magnetic Circuit: MMF, Magnetizing force, Magnetic flux and flux density, permeability, Reluctance and
permeance, B-H curve, simple magnetic circuits, Hysteresis and eddy current loss.
Transformers Single-phase transformer Construction, principle of operation, EMF equation, phase diagram
on no-load and full-load, losses and efficiency, open and short circuit test, auto transformer.
D. C. Machines: Construction, EMF equation, various types and characteristics D. C. Generator Principle,
torque and speed formula, types and their characteristics, Speed control.
Module IV
10H
Semiconductor Devices: Semiconductor Diode and its V-I characteristics, Rectifier circuit, Various types of
diodes, Zener diode, PIN Diode, Light emitting diode, gun diode Semiconductor BJT, Working principle,
Transistors in CC, CE, and CB configurations, transistor biasing, V-I characteristics and load line concept
with Quiescent point, Transistor H parameter.
Laboratory Experiments
16H
Introduction and familiarization to the lab equipment’s and common components:
a) Study of CRO
b) Study of Function generator
c) Study of Multimeter
d) Familiarization with Breadboard, resistances, capacitances, diodes, transistors, etc.
Study of PN-Junction Diode Characteristics: To study and plot the forward and reverse bias characteristics
of a general purpose pn junction diode.
Study of half-wave rectifier circuit: To construct a half-wave rectifier circuit, and observe waveforms and
find average output.
Study of center-tapped full-wave rectifier circuit: To construct a full-wave rectifier circuit, and observe
waveforms and find average output.
Study of Zener Diode as a Voltage Regulator: To study and analyze use of a Zener diode as a voltage
regulator.
Study of Bipolar Junction Transistor Characteristics in CE mode: To study the input and output
characteristics of a BJT in Common Emitter mode.
Study of Bipolar Junction Transistor Characteristics in CB mode: To study the input and output
characteristics of a BJT in Common Base mode.
Study of Common Emitter Transistor as an Amplifier: To design a common emitter transistor amplifier
circuit and observe the frequency response of the amplifier.
Study of a Series Resonant Circuit: To study the behavior of a series LCR resonant circuit and to estimate
the resonant frequency and Q-factor.
Text/Reference books:
1. V. Del Toro, “Electrical Engineering Fundamentals,” 2e, Prentice Hall of India 1994.
2. Millman Jacob and Christos C. Halkias, “Integrated Electronics: Analog and Digital Circuits and Systems,”
McGraw Hill, 2004.
3. Robert L. Boylestad and Louis Nashelsky, “Electronics Device and Circuit Theory,” 9e, Pearson Education India,
2005.