Case Study 3: Material Selection for a Corrosion-Resistant Chemical Storage Tank (Metal-Focused)
Background
A specialty chemicals company stores an aqueous sodium hypochlorite solution (NaOCl, 10–15 wt%) for use in water
treatment. The solution is kept in an indoor storage tank (500–1000 L capacity) located in a processing area. The design
team asks you to recommend a suitable metallic material for the storage tank using a structured material selection
approach.
Problem
The storage tank must satisfy the following requirements:
Chemical Resistance
•
Continuous contact with 10–15 wt% sodium hypochlorite, a strong oxidizing and corrosive solution
•
The material must resist uniform corrosion, pitting, and rapid degradation
•
No significant contamination of the stored chemical is acceptable
Temperature Conditions
•
Normal operating temperature: 10–35 °C
•
Occasional temperature excursions up to 45 °C
Mechanical Integrity
•
Must withstand hydrostatic loading due to the stored liquid
•
Must retain mechanical integrity over long service times
•
Tank operates near atmospheric pressure (not a pressure vessel)
Fabrication & Joining
•
Must be suitable for welding and fabrication using standard industrial methods
•
Welded joints must maintain corrosion resistance comparable to the base material
Cost & Practicality
•
Material should be economically reasonable for repeated industrial installations
•
Extremely exotic or laboratory-only materials should be avoided
Sustainability & Safety
•
Prefer materials with long service life and recyclability
•
Avoid materials that produce hazardous corrosion products or fail unexpectedly
Your Task
1.
2.
3.
4.
Convert operating conditions into required material properties.
Identify at least three candidate materials for the membrane housing.
Select the best candidate material and justify your decision.
Recommend a manufacturing route for the housing.
Deliverable (1–2 pages)
•
•
•
Comparative property table
Justification of final material choice
Explanation of manufacturing and joining methods
Later Extension – Failure & Mitigation Analysis
Propose one likely failure mode for your selected material and one mitigation strategy.