Accomplishments
•
•
•
•
Updated our BOM by adding the T-Cycle chain tensioner
There was an issue that all off the shelf chain tensioners had
clamps that were too large, so we used shaft collars to
accommodate for the difference in diameters
Finished the CAD for the prototype by adding the chain
tensioners and idlers
These past 2 weeks I learned to communicate when conflicts
come up so my team isn’t set back
T-cycle chainring added to BOM
Prototype CAD with tensioners and idlers
Shaft collars to resolve sizing issue
Work to do
•
Planning on having drivetrain prototype complete
and built by 11/25/25
•
•
•
•
Must assemble all the components from out BOM and
show that our drivetrain design is functional and efficient
Build all parts of the prototype to ensure all components
work together
Test to see where we can improve upon our design
Finish testing the prototype by 12/2/25
•
•
•
•
The prototype should be fully working, with components
like the rear wheel, rear derailleur, cassette, chain, idlers,
chain tensioners, crankset, and motor
Ensure rear derailleur is able to shift properly and
smoothly
Run tests on the prototype at different power levels
Run tests to see if all parts are working at full efficiency