4. Passive radiative cooling
When we place an object in the sun on a hot day, we typically expect the object to heat up.
However, it is possible to construct a device that will cool below the ambient air temperature
when placed under direct sunlight if the following conditions are met:
(1) The device must reflect over 90% of the incident sunlight to minimize heating.
(2) The device must emit strongly in the atmospheric transparency window of roughly 8 – 13
μm. In this spectral range, the device can radiate heat directly to deep space, which has a
temperature Tspace = 0 K.
(3) The device must experience minimal heating via convection from ambient air.
Researchers at Stanford University successfully built such a passive radiative cooling device
in 2014 [1], and commercial passive radiative cooling materials are now under development [2].
In this problem, you will analyze the conditions necessary to achieve passive radiative cooling.
[1] A.P. Raman et al., “Passive radiative cooling below ambient air temperature under direct sunlight,”
Nature 515, 540-544 (2014).
[2] http://radi-cool.com/
(a) At steady state, the emitted radiative heat flux from the device to deep space qem, must
balance the absorbed solar heat flux qabs and the convection heat flux qconv from the
ambient air to the device. Write down the governing energy balance for this situation in
terms of the variables qem, qabs, and qconv.
9 em
9 son
t
9 solar
or
9rem Gow Goran O
(b) The spectral emissivity of the device is shown in the plot below (assume the device to be
diffuse). If the device operates at T = 290 K, what is qem? Although the atmospheric
transparency window technically only extends to ~13 μm, assume that for wavelengths
between 10 and 20 μm, heat is radiated directly to deep space. Use Table 12-2 to find the
*(→! fractions. For values of λT not explicitly given in Table 12-2, you may round your
answer and use the closest value of λT given in the table.
Emissivity ελ
0.75
0.25
0
10
0
13
20
Wavelength λ [μm]
10 pm 5290 K
2900
µm K
13 pm 290 K
3770µm K
20 pm 290 K
5800 µm K
Gem
GT
Fo topm
f
t
GT
t
20pm
Foo3pm fo
8
Fo gopmis O 27
fo 13µm I 0.44
fo
20 pm
fo 13pm 7 D t f s
50.72
pm
257
O
op
0.75 t
fo aopmfo 3pm0.25
5.67 10 mtg4290k GO 44 0.27 0.75 t 0.72 0.440.25
9 em
79
I
m2
(c) Based on your answers to parts (a) and (b), if the solar irradiation Gsolar = 800 W/m2 and
the absorptivity for wavelengths corresponding to solar emission is αsolar = 0.03 (in
other words, qabs = αsolarGsolar) what is the convection coefficient h such that the device
cools 5 K below the ambient air temperature Tair?
9cm
9 cow t 9 solar
9 solar
solarGabs
9am h Tain Tsurfaced
79
Img
h
5k
t 0.03
h
11
mK
800 Wmg
5K