Assignment: Diffusion and Implant
Q1 A 1 × 1014 cm-2 phosphorus implant through a 200-nm Si02, mask layer is performed so
the peak concentration is at the silicon silicon/SiO2, interface. An anneal a is then performed
for 30 min at 1000°C. Calculate the location of the junction with substrate doped at 1 x 10 15
cm-3. Assume no diffusion in the masking layer and ignore any segregation effects. Assume
the same range statistics for SiO2 and Si.
Q2 An 80-keV, 5 x 1013 cm-2 boron implant is performed into bare silicon. A subsequent
anneal at 950°C is performed for 60 min.
a. Can the annealed profile evolution be described by the following formulas?
b. Assume that all the dopants remain in the silicon and that none evaporates to the ambient.
By considering a virtual or imaginary image profile on the ambient side of the interface (a
reflecting boundary), calculate the surface concentration after a 60-min 950°C anneal.
Q3 If EC is critical energy for nuclear stopping, then show that approximately the critical dose
for amorphisation is
(a) Ncrit = 8∆RpEd/E0 where Ed is energy needed to create vacancy defect and E0 is > Ec and is
incident beam energy.
(b) Find out critical dose for amorphisation 100 keV B and As ions implanted into silicon.
Q4 As the engineer worried about avoiding punch-through in the NMOS device decides to
perform a deep punch-through implant while keeping the surface concentration at a
maximum value of 1 x 1017 cm-3. What is the maximum implant dose that would be suitable
if the peak of the profile is aligned at twice the depth of the deep source/drain contact
junction in a 180 nm technology? (Assume Xj = 0.05 µm)
Q5 Desing n-well which has a sheet resistance on 800 Ohm/sq, Xj = 3um on Si wafer p-type
doping 1E15.
Q6 A p-type (boron) diffusion is performed as follows:
Predep: 30 minutes, 900°C, solid solubility, Drive in: 60 minutes, 1000°C
a. What is the deposited Q?
b. If the substrate is doped 1 x 1015 cm-3 phosphorus, what is x?
c. What is the sheet resistance of the diffused layer?