CESSNA MODEL 172S
NAV III NXi AVIONICS OPTION - GFC 700 AFCS
Serials 172S13231 and On
SUPPLEMENT 9
DUAL ELECTRONIC IGNITION SYSTEM (EIS)
SERIAL NO.
REGISTRATION NO.
This supplement must be inserted into Section 9 of the Pilot's Operating Handbook
and FAA Approved Airplane Flight Manual when the Dual Electronic Ignition
System (EIS) is installed.
COPYRIGHT © 2025
TEXTRON AVIATION INC.
WICHITA, KANSAS, USA
172SPHCUS-S9-00
2 APRIL 2025
U.S.
S9-1
SECTION 9 - SUPPLEMENTS
SUPPLEMENT 9
CESSNA
MODEL 172S NAV III NXi
GFC 700 AFCS
SUPPLEMENT
DUAL ELECTRONIC IGNITION SYSTEM (EIS)
Use the Log of Effective Pages to determine the current status of this
supplement.
Pages affected by the current revision are indicated by an asterisk (*)
preceding the page number.
Supplement Status
Original Issue
Date
2 April 2025
LOG OF EFFECTIVE PAGES
S9-2
Page
Number
Page
Status
Revision
Number
S9-1 thru S9-6
Original
0
U.S.
FAA APPROVED
172SPHCUS-S9-00
CESSNA
MODEL 172S NAV III NXi
GFC 700 AFCS
SECTION 9 - SUPPLEMENTS
SUPPLEMENT 9
SERVICE BULLETIN CONFIGURATION LIST
The following is a list of Service Bulletins that are applicable to the
operation of the airplane, and have been incorporated into this
supplement. This list contains only those Service Bulletins that are
currently active.
Number Title
Airplane Serial Revision
Effectivity
FAA APPROVED
172SPHCUS-S9-00
Incorporated
Incorporated in Airplane
U.S
S9-3
SECTION 9 - SUPPLEMENTS
SUPPLEMENT 9
CESSNA
MODEL 172S NAV III NXi
GFC 700 AFCS
DUAL ELECTRONIC IGNITION SYSTEM (EIS)
GENERAL
The Dual Lycoming Electronic Ignition System (EIS) replaces the
standard magnetos. They require a constant, external supply of 8.5 –
30 VDC power to operate and draw 0.35 Amp each.
During normal operations, electrical power to the EIS is supplied from
the alternator, providing power to all electrical systems including the
EIS. Upon loss of alternator power, the standby battery will support
essential loads for at least 30 minutes including to the EIS system.
Extended EIS operational time beyond 30 minutes is enabled through
load shedding procedures. The EIS modules have no controls other
than the ignition switch and are tied via 10 Amp fuses directly to both
the main and standby batteries, with each source being isolated from
the other.
CAS messages, and an informational message, alert the pilot when the
EIS is operating on main battery power. Once the main battery begins
to discharge at a rate of 1.5 Amps or greater while in flight, the G1000
system senses the discharge and a red IGN PWR FAIL CAS message
comes on, which indicating that the EIS is being powered solely by the
main battery. A white message in the alerts window - IGNITION
POWER FAIL – ENGINE FAILURE IN 30 MINUTES will also display
with the red IGN PWR FAIL CAS message. When the red IGN PWR
FAIL CAS message comes on, the pilot should attempt to reset the
alternator control unit to restore power. If a reset is not possible, isolate
main battery power for exclusive use by the EIS by turning the
MASTER switch OFF. The G1000 PFD and GEA will remain on using
standby battery power and will detect a discharge on the main battery
is no longer present and the voltage levels at the EIS modules are
greater than approximately 23.5 Volts. The amber CAS message IGN
ON BATT will come on and the red IGN PWR FAIL CAS message and
its associated alert message will clear. If the load shedding procedures
are not completed or the main battery is depleted below 23.5 Volts,
then the red IGN PWR FAIL CAS message will remain on or return.
Land the airplane as soon as possible.
OPERATING LIMITATIONS
The 24V Standby Battery and Standby Ammeter must successfully
complete the pre-flight check before flight.
(Continued Next Page)
S9-4
U.S.
FAA APPROVED
172SPHCUS-S9-00
CESSNA
MODEL 172S NAV III NXi
GFC 700 AFCS
SECTION 9 - SUPPLEMENTS
SUPPLEMENT 9
OPERATING LIMITATIONS (Continued)
Minimum MAIN and ESS BUS VOLTS for takeoff is 27.5 VDC (Green
digits).
Maximum MAIN BATT AMPS for takeoff is 4 AMPS (Green digits).
Maximum STBY BATT AMPS for takeoff is 3 AMPS (Green digits).
EMERGENCY PROCEDURES
RED IGN PWR FAIL ANNUNCIATOR COMES ON
1.
2.
3.
4.
5.
6.
MASTER Switch (ALT Only) - OFF
ALT FIELD Circuit Breaker - CHECK IN
MASTER Switch (ALT and BAT) - ON
IGN PWR FAIL Annunciator - CHECK OFF
M BUS VOLTS - CHECK 27.5 V (minimum)
M BATT AMPS - CHECK CHARGING (+)
IF RED IGN PWR FAIL ANNUNCIATOR REMAINS ON
7. MASTER Switch (ALT and BAT) - OFF
8. Red IGN PWR FAIL Annunciator - VERIFY EXTINGUISHED
9. Amber IGN ON BATT Annunciator - VERIFY ON
10. Land as soon as practical.
NOTE
• With the MASTER switch OFF and IGN PWR FAIL
extinguished, the remaining power available to the
Electronic Ignition system exceeds the fuel capacity of
the airplane. The avionics on the essential bus will
continue to operate off of the standby battery until
exhausted.
• If Landing Lights or Flaps are required for landing, do not
turn the MASTER Switch (BAT) ON until landing is
assured.
IF RED IGN PWR FAIL ANNUNCIATOR REMAINS ON OR COMES
ON AGAIN
11. Land as soon as possible.
FAA APPROVED
172SPHCUS-S9-00
U.S
S9-5
SECTION 9 - SUPPLEMENTS
SUPPLEMENT 9
CESSNA
MODEL 172S NAV III NXi
GFC 700 AFCS
NORMAL PROCEDURES
PREFLIGHT INSPECTION
CABIN
Perform the following step after OIL PRESSURE Annunciator - CHECK
(verify annunciator is shown)
IGN ON BATT Annunciator - CHECK (verify annunciator is shown)
BEFORE TAKEOFF
Perform the following step after Throttle Control - CHECK IDLE
IGN ON BATT Annunciator - CHECK (verify annunciator is shown)
PERFORMANCE
There is no change to the airplane performance when the Lycoming Dual
Electronic Ignition is installed.
S9-6
U.S.
FAA APPROVED
172SPHCUS-S9-00