Corner Velocity Explained
Definition:
Corner velocity (Va) is the speed at which the aircraft can achieve its maximum
allowable load factor (n_limit) before stalling.
Formula:
Va = Vs * sqrt(n_limit)
Where:
- Vs = stall speed (clean configuration)
- n_limit = design limit load factor
Example Calculation:
Suppose a light aircraft has:
- Stall speed Vs = 48 knots
- Limit load factor n_limit = 3.8
Va = 48 * sqrt(3.8) 48 * 1.95 94 knots
Interpretation:
At 94 knots, the aircraft will stall if you pull to the maximum allowable load factor.
Above this speed, you could exceed the structural limit before stalling so Va is the
maximum safe speed for abrupt maneuvers.
V-N Diagram with Corner Velocity
6
5
4
Load Factor (g)
3
Stall Line (+)
Stall Line (-)
Limit Load (+3.8g)
Limit Load (-1.52g)
Ultimate Load (+5.7g)
Ultimate Load (-2.28g)
Corner Velocity (Va 93.6 knots)
2
1
0
1
2
3
0
25
50
75
100
Velocity (knots)
125
150
175
200
Example Problems for Students
Problem 1: Calculating Load Factor in a Turn
A Cessna 172 is flying at 100 knots in a level, coordinated 60° banked turn.
What is the load factor experienced by the aircraft?
Solution:
n = 1 / cos( ) = 1 / cos(60°) = 1 / 0.5 = 2.0
The aircraft experiences a load factor of 2g.
Problem 2: Finding Corner Velocity
Given:
- Stall speed Vs = 50 knots
- Limit load factor n_limit = 4.4 (utility category)
Va = Vs * sqrt(n_limit) = 50 * sqrt(4.4) 105 knots
Problem 3: Interpreting the V-N Diagram
Given:
- Limit load factor: +3.8g, -1.52g
- Ultimate load factor: +5.7g, -2.28g
- Stall speed: 48 knots
- Never exceed speed (Vne): 163 knots
Questions:
a) What happens if the pilot pulls 4g at 120 knots?
b) What is the significance of the region above the red line but below the orange
line?
Answers:
a) 4g exceeds the limit load (3.8g), risking permanent deformation.
b) The region between limit and ultimate load is where the structure may deform
but should not fail this is the safety margin.
Problem 4: Accelerated Stall
If a pilot pulls a 3g maneuver, at what speed will the aircraft stall if the 1g stall
speed is 50 knots?
Solution:
V_stall_3g = Vs * sqrt(n) = 50 * sqrt(3) 86.6 knots
Problem 5: Design Loads
Explain the difference between design limit load and design ultimate load. Why is a
safety factor used?
Answer:
- Design limit load: Maximum load expected in normal operation no permanent
deformation.
Load Factor vs Bank Angle
Load Factor (g)
5
4
3
2
1
0
10
20
30
40
50
Bank Angle (degrees)
60
70
80
Accelerated Stall Speed vs Load Factor
110
Stall Speed (knots)
100
90
80
70
60
50
1.0
1.5
2.0
2.5
3.0
Load Factor (g)
3.5
4.0
4.5
5.0