JMJ Marist Brothers
College of Engineering and Technology
NOTRE DAME OF MARBEL UNIVERSITY
City of Koronadal, South Cotabato
Laboratory Activity: Basic LAN Setup
Objective:
This lab will test your ability to configure basic settings such as IP Address, and Subnet
mask on end devices emulated in Packet Tracer and test the connectivity.
Network Diagram:
Laboratory Instructions:
1. Recreate the given network structure in Cisco Packet Tracer.
2. Each lab is located on a different wiring closet.
3. The center switch and the fileservers are located in another wiring closet.
a. Use an empty switch and add Gigabit Ethernet Network Module (part number
PT-SWITCH-NM-1CGE) to connect each laboratory room.
4. Wiring closet should be defined properly in the physical workspace of the cisco packet
tracer.
a. Switch and end devices (host)
JMJ Marist Brothers
College of Engineering and Technology
NOTRE DAME OF MARBEL UNIVERSITY
City of Koronadal, South Cotabato
5. Configure the IP address of the PC’s with static IP addresses based on its given
network.
Network
Lab 1
192.168.10.0
255.255.255.0
Lab 2
192.168.100.0
255.255.255.0
Lab 3
192.168.200.0
255.255.255.0
Lab 4
192.168.50.0
255.255.255.0
Device
Fileserver
PC 1-5
PC 6-10
Fileserver
PC 1-5
PC 6-10
Fileserver
PC 1-5
PC 6-10
Fileserver
PC 1-5
PC 6-10
IP Address
192.168.10.2
192.168.10.3 – 192.168.10.7
192.168.10.250 – 192.168.10.254
192.168.100.2
192.168.100.3 – 192.168.100.7
192.168.100.250 – 192.168.100.254
192.168.200.2
192.168.200.3 – 192.168.200.7
192.168.200.250 – 192.168.200.254
192.168.50.2
192.168.50.3 – 192.168.50.7
192.168.50.250 – 192.168.50.254
6. Test connectivity from network to network using “ping”.
a. Laboratory to corresponding file Fileserver
b. Laboratory to other Laboratory fileserver
c. Laboratory to other Laboratory
d. Fileserver to other Fileserver