Uploaded by gianuzzig

ADF

advertisement
Thai
เลือกภาษาไทย
AIRCRAFT NAVIGATION SYSTEM
Aircraft
Navigation
Navigation Introduction
V H F Omni Range
VOR
Automatic Direction
Finder
ADF
AUTOMATIC DIRECTION FINDER
ADF (Automatic Direction Finder) is the radio signals in the low to medium frequency
band of 190 Khz. to 1750 Khz. It was widely used today. It has the major advantage
over VOR navigation in the reception is not limited to line of sight distance. The ADF
signals follow the curvature of the earth. The maximum of distance is depend on the
power of the beacon. The ADF can receives on both AM radio station and NDB (NonDirectional Beacon). Commercial AM radio stations broadcast on 540 to 1620 Khz.
Non-Directional Beacon operate in the frequency band of 190 to 535 Khz.
ADF COMPONENTS
ADF Receiver : pilot can tune the station desired and to select the mode of
operation. The signal is received, amplified, and converted to audible voice or morse
code transmission and powers the bearing indicator.
Long Range Navigation
LORAN
Global Positioning
System
GPS
Control Box (Digital Readout Type) : Most modern aircraft has this type of control
in the cockpit . In this equipment the frequency tuned is displayed as digital readout.
ADF automatically determines bearing to selected station and it on the RMI.
Antenna : The aircraft consist of two antennas. The two antennas are called
LOOP antenna and SENSE antenna. The ADF receives signals on both loop and
sense antennas. The loop antenna in common use today is a small flat antenna
without moving parts. Within the antenna are several coils spaced at various angles.
The loop antenna sense the direction of the station by the strength of the signal on
each coil but cannot determine whether the bearing is TO or FROM the station. The
sense antenna provides this latter information.
Bearing Indicator : displays the bearing to station relative to the nose of the
aircraft.
Relative Bearing is the angle formed by the line drawn through the center line of the
aircraft and a line drawn from the aircraft to the radio station.
Magnetic Bearing is the angle formed by a line drawn from aircraft to the radio
station and a line drawn from the aircraft to magnetic north (Bearing to station).
Magnetic Bearing = Magnetic Heading + Relative Bearing.
TYPE OF ADF INDICATOR
Four types of ADF indicators are in use today. In every case, the needle points to the
navigation beacon.Those four types are:
Fixed Compass Card : It is fixed to the face of instrument and cannot rotate. 0
degree is always straight up as the nose of aircraft.
The relationship of the aircraft to the station is refered to as " bearing to the station "
MB or aircraft to magnetic north. This type of indicator, pilot must calculate for the
bearing by formular
MB = RB + MH
Rotatable Compass Card : The dial face of the instrument can be rotated by a
knob. By rotating the card such that the Magnetic Heading (MH) of the aircraft is
adjusted to be under the pointer at the top of the card.
The bearing to station (MB) can be read directly from the compass card without
calculation and make it easy for pilot. Today , they designed automatically rotate the
compass card of the instrument to agree with the magnetic heading (MH) of the
aircraft . Thus MB to station can be read at any time without manually rotating the
compass card on the ADF face.
Single-Needle Radio Magnetic Indicator : Radio Magnetic Indicator is an
instrument that combines radio and magnetic information to provide continuous
heading , bearing , and radial information.
The face of the single needle RMI is similar to that of the rotatable card ADF.
Dual-Needle Radio Magnetic Indicator : The dual needle RMI is similar to single
needle RMI except that it has a second needle. The first needle indicated just like
single needle. inthe picture , the yellow needle is a single which indicate the
Magnetic Bearing to the NDB station . The second needle is the green needle in the
picture.
The second needle (green) is point to VOR station .The dual needle indicator is
useful in locate the location of an aircraft.
OPERATION
ADF operate in the low and medium frequency bands. By tuning to NDB station or
commercial AM radio stations. NDB frequency and identification information may be
obtained from aeronautical charts and Airport Facility Directory. The ADF has
automatic direction seeking qualities which result in the bearing indicator always
pointing to the station to which it is tuned. The easiest and perhaps the most
common method of using ADF , is to " home " to the station . Since the ADF pointer
always points to the station , the pilot can simply head the airplane so that the
pointer is on the 0 (zero) degree or nose position when using a fixed card ADF . The
station will be directly ahead of the airplane. Since there is almost always some wind
at altitude and you will be allowing for drif, meaning that your heading will be
different from your track. Off track , if the aircraft is left of track, the head of the
needle will point right of the nose. If the aircraft is right of track , the head of the
needle will point left of the nose.
For fixed compass card , if you are not fly Homing and you want to fly heading at
some degrees. You must use the formular MB = MH + RB to find out what degree the
ADF pointer should be on. Today , the fixed card indicator is very unsatisfactory for
every day use which can still be found on aircraft panels but not many planes that
pilot actually uses it due to it has easier type of indicator.
For rotatable compass card, it was a big step over the fixed card indicator. The
pilot can rotate the compass card with the heading knob to display the aircraft MH "
straight up " . Then the ADF needle will directly indicate the magnetic bearing to the
NDB station.
For Single needle Radio Magnetic Indicator , the compasscard is a directional
gyro and it rotates automatically as the aircraft turns and provide continuous
heading . It is accurately indicates the magnetic heading and the magnetic bearing
to the beacon. This instrument is a " hands off " instrument.
For dual needle Radio Magnetic Indicator, it is give the pilot information the same
as the single needle such as aircraft heading and magnetic bearing to the NDB . The
seacond indicator will point to VOR station . This help pilot to check the location of
the aircraft at that time .
© 2001-2007 Thai Technics.Com All Rights Reserved
Contact Webmaster
Download