Centennial College
Electrical Engineering Technician / Technology
EET-115 Installation Methods 1
Name:
Student #:
Section:
Date:
LAB #1
Installing Non-Metallic Sheathed Cable
Objectives:
•
To understand basic hand tool safety and correctly terminate NMSC on switches and receptacles.
Materials & Tools Required:
●
●
●
●
●
#14/2 NMD90 Cable (Romex)
120 Volt 15A Receptables
120 Volt 15A Single Pole Switches
Device Boxes
Lamp Holder
Linesmen Pliers
● Screwdrivers (Various)
● Needle-nose Pliers
● Wire Strippers
●
NOTE: Do not install any improper or damaged components. Wiring must be performed to meet
current electrical code requirements.
Installation Instructions:
•
•
•
•
•
Class review of hand tool kits and proper safety.
Demonstrate correct technique for stripping wire.
Terminate stripped wire on switch, receptacle and lamp holder.
Have instructor review finished connections.
Answer all questions for this lab listed below.
Page 1 of 2
Questions: State the CEC rule number if the code book is used.
1. List three important points when stripping and terminating NMSC
2. What do you think is the most important wire in this cable and why?
3. Can the cable used in this lab (NMD) be used in wet locations?
4. Where would one find the information of NMSC?
5. What color screw on the receptacle is used for the black, white and bare wires?
Instructor Signature
LAB MARK
QUESTIONS
TOTAL MARK
10
5
15
Page 2 of 2