Future Design & Concept
Luke Parr, Electronic Communications, School of Engineering, Newcastle University
Printed Circuit Board Design
3D Enclosure Design
Figure 3: Step 1 - The
placement of the bottom
enclosure. The design includes the holes for
screws, cut out gap for
the display and three
holes for the switches.
Figure 1: The top side of
the PCB using Gerber
Files including components DHT22, SX1276
and Arduino Nano.
Figure 4: Step 2 - The
placement of the PCB
into the bottom enclosure
ensuring to keep the battery in the bottttom..
Figure 2: The bottom
side of the PCB iincluding
LCD screen, switches
and 9V battery supply.
Contact: Luke Parr
Email: B9039193@Newcastle.ac.uk
Supervisors: Domenico Balsamo & Rishad Shafik
Figure 5: Step 3 –The
placement of the top enclosure ensuring the holes
and side openings line up
with the sensor and antenna.