EC2091D Devices and Networks Lab Experiment-4: Clipper and clamper circuits Aim: To study the diode applications in a clipping and clamping circuits.: a) b) c) d) e) Series negative clipper. Series positive clipper (with a battery in series) Parallel clipper with threshold Double ended clipper. Negative Clamper. (a) Series negative clipper: Circuit Diagram: Use IN4007 diode for D, R= 10 kΩ Procedure: 1. Connect the circuit as per the circuit diagram 2. Set input signal voltage (5V, 1 kHz , sinusoidal) using signal generator. 3. Observe the output waveform using CRO 4. Sketch the observed waveforms. 5. Repeat the same procedure for square wave input (5V, 1 kHz) 1 Model waveform: 1. Sinusoidal input 2. Square wave input (b) Series positive clipper (with a battery in series): Circuit Diagram: Use IN4007 diode, R= 1 kΩ, VRef = 2V. Procedure: 1. Connect the circuit as per the circuit diagram 2. 3. 4. 5. Set input signal voltage ( 5V, 1 kHz , sinusoidal) using signal generator. Observe the output waveform using CRO Sketch the observed waveforms. Repeat the same procedure for square wave input (5V, 1 kHz) Model Graph: 1. Sinusoidal input 3 2. Square wave input (c) Parallel clipper: Circuit Diagram: Use IN4007 diode, R= 1 kΩ, VRef = 2V. Procedure: 1. Connect the circuit as per the circuit diagram 2. 3. 4. 5. Set input signal voltage (5V, 1 kHz , sinusoidal) using signal generator. Observe the output waveform using CRO Sketch the observed waveforms. Repeat the same procedure for square wave input (5V, 1 kHz) Model waveform: 1. Sinusoidal input 5 2. Square wave input (d) Double ended clipper: Circuit Diagram: Use IN4007 diode, R= 10 kΩ, VRef1 = 2V, Vref2 = 1V Procedure: 1. Connect the circuit as per the circuit diagram 2. 3. 4. 5. Set input signal voltage (5V, 1 kHz , sinusoidal) using signal generator. Observe the output waveform using CRO Sketch the observed waveforms. Repeat the same procedure for square wave input (5V, 1 kHz) Model Graph: 1. Sinusoidal input 2. Square wave input 7 (e) Negative Clamper: Circuit Diagram: R= 1 kΩ; D =IN4007, 𝐶 = 1μ𝐹. Procedure: 1. Connect the circuit as per the circuit diagram 2. 3. 4. 5. Set input signal voltage (5V, 1 kHz , sinusoidal) using signal generator. Observe the output waveform using CRO Sketch the observed waveforms. Repeat the same procedure for square wave input (5V, 1 kHz) Model waveform: 1. Sinusoidal input 2. Square wave input. 9