GOVERNMENT COLLEGE OF TECHNOLOGY, DERA ISMAIL KHAN
UNIVERSITY OF ENGINEERING AND TECHNOLOGY
BSc Electrical Engineering Technology
Final-Term Examination Fall 2021
Drawing
(Part –I Time: 15mins)
1st Semester
Student Roll #:_________________
Marks: 20
Note: This section contains 10 objective type questions. The time allowed is fifteen minutes
after which you must return this section.
1. Trimmed size of _______________ size paper is 210x297
a. A5
b. A3
c. A2
d. A4
2. Femto meter is equal to _______________ m.
a. 10-12
b. 10-15
c. 10-18
d. 1015
3.
is the symbol of _______________ .
a. Trimmer
b. variable inductor
c. Variable resistor
d. Electrolytic capacitor
4.
is the symbol of _______________ size paper is 210x297
a. Silicon Diode
b. SCR
c. Transistor
d. Rectifier
5. If main title of the drawing is of 8mm what is the size in mm of subtitle _______________.
a. 16mm
b. 10mm
c. 5mm
d. 4mm
6. Holes are dimensioned by stating their _______________ .
a. Circumference
b. Diameter
c. Radius
d. Length
7. In orthogonal projections the planes are at ________ degree to each other.
a. 90
b. 120
c. 45
d. 360
8. Object is assumed to be place between observer and planes of projection.
a. First Angle projection
b. Second Angel Projection
c. Third Angle projection
d. Fourth Angel Projection
9. What is the symbol of varactor diode?
a.
b.
c.
d.
10. One hectometer is equal to _______________.
a. 103
b. 102
9
c. 10
d. 106
GOVERNMENT COLLEGE OF TECHNOLOGY, DERA ISMAIL KHAN
UNIVERSITY OF ENGINEERING AND TECHNOLOGY
BSc Electrical Engineering Technology
Final-Term Examination Fall 2021
Drawing
Student Roll #:_________________
1st Semester
Marks: 80
Note: Attempt all questions. Q#1 must be attempted on proper drawing sheet.
Q#1: Draw orthogonal projections of the object shown in the figure below.
30
Q#2: Draw single line diagram of an indoor substation.
15
Q#3: Design and draw a developed winding diagram for a 16 slots, double layer, 4 pole, DC lap
winding. Make provision for equalizer rings.
20
Q#4: Write a detail note on types of projections in engineering drawings.
15